[Ailun] How to install screen protector on iPhone 16 Pro /16 Pro Max (with Installation Frame)

Introduction

This tutorial provides a step-by-step guide on how to install a screen protector on your iPhone 16 Pro or 16 Pro Max using an installation frame. Proper installation is crucial for ensuring that the screen protector adheres well, providing optimal protection for your device.

Step 1: Gather Your Materials

Before you begin the installation process, make sure you have the following items ready:

• Ailun screen protector (specifically for iPhone 16 Pro or 16 Pro Max)
• Installation frame (included with the screen protector)
• Cleaning cloth (usually provided)
• Dust removal sticker
• A credit card or similar flat object (for smoothing out bubbles)

Step 2: Clean Your Device Screen

A clean surface is key to a successful application. Follow these sub-steps:

1. Use the Cleaning Cloth: Wipe the screen gently with the cleaning cloth to remove fingerprints, smudges, and dust.
2. Remove Dust: Use the dust removal sticker to lift off any remaining dust particles from the screen. Ensure there are no specks left on the surface.

Step 3: Prepare the Installation Frame

The installation frame helps position the screen protector accurately. Here’s how to set it up:

1. Align the Frame: Place the installation frame over the iPhone screen. It should fit snugly around the edges without any gaps.
2. Secure the Frame: If the frame has adhesive strips, use them to secure it in place. This prevents movement during installation.

Step 4: Apply the Screen Protector

Now it’s time to apply the screen protector. Follow these steps carefully:

1. Peel Off the Backing: Take the screen protector and peel off the protective layer on the back side. Avoid touching the adhesive side to prevent fingerprints.
2. Position the Protector: Align the screen protector with the installation frame. Ensure it fits perfectly over the screen.
3. Lower the Protector: Slowly lower the screen protector onto the screen, starting from one edge and allowing it to fall into place.

Step 5: Smooth Out Bubbles

After the protector is in place, it’s important to eliminate any air bubbles:

1. Use the Credit Card: Take the edge of the credit card and gently push out any bubbles from the center towards the edges.
2. Repeat if Necessary: If bubbles persist, lift the protector slightly and reapply, then smooth out again.

Step 6: Final Touches

Once you have smoothed out the screen protector, complete the installation:

1. Remove the Frame: Carefully lift the installation frame away from the device.
2. Check for Bubbles: Inspect the screen for any remaining bubbles. Repeat smoothing if needed.
3. Clean the Surface: Wipe the surface of the screen protector with the cleaning cloth to remove any fingerprints.

Conclusion

You have successfully installed your Ailun screen protector on your iPhone 16 Pro or 16 Pro Max. Remember to handle your device with care to maintain the integrity of the screen protector. If any bubbles remain after a day or two, they may resolve themselves, but you can always re-smooth them with the credit card method. Enjoy your protected screen!