Toyota Camry Rear Brake Pad Replacement With Electronic Brake 2018 - 2023

Introduction

This tutorial will guide you through the process of replacing the rear brake pads on a 2020 Toyota Camry XLE equipped with an electronic parking brake. Properly maintaining your brake system is crucial for vehicle safety and performance. Follow these steps to successfully complete the replacement.

Step 1: Gather Necessary Tools and Parts

Before you begin, ensure you have all the required tools and parts. This will make the process smoother.

Required Tools

• 3/8" ratchet
• 14mm socket (3/8")
• 3/8" torque wrench (for caliper bolts)
• 1/2" torque wrench (for wheel lug nuts)
• Flat head screwdriver (alternate for compressing the brake piston)
• Brake piston compressor (optional, a flat head screwdriver can be used)

Required Parts

• Rear brake pads: 04466-0E070
• Shim kit (optional): 04946-02120

Step 2: Prepare the Vehicle

Ensure you are working in a safe environment.

Safety Precautions

• Use personal protective equipment (PPE) such as gloves and safety glasses.
• Park the vehicle on a flat surface and engage the parking brake.
• If necessary, block the front wheels to prevent movement.

Lifting the Vehicle

1. Loosen the lug nuts on the rear wheels slightly while the vehicle is still on the ground.
2. Use a jack to lift the rear of the vehicle.
3. Secure the vehicle with jack stands.

Step 3: Remove the Wheel

1. Fully remove the loosened lug nuts.
2. Take off the rear wheel and set it aside.

Step 4: Access the Brake Caliper

1. Locate the brake caliper, which houses the brake pads.
2. Use the 14mm socket and ratchet to remove the caliper bolts.

Step 5: Remove Old Brake Pads

1. Carefully slide the caliper off the rotor.
2. Remove the old brake pads from the caliper bracket.
3. Inspect the rotor for wear. Ensure the rotor thickness is above the minimum specification of 10.5 mm (0.414 in) for vehicles with an electronic parking brake.

Step 6: Compress the Brake Piston

1. Use a brake piston compressor or a flat head screwdriver to push the brake piston back into the caliper.
   • Note: The piston does not need to be turned, so a screwdriver or prybar can be effective.
2. Ensure the piston is fully retracted to allow for the new brake pads to fit.

Step 7: Install New Brake Pads

1. Place the new brake pads into the caliper bracket.
2. Ensure they are seated properly.

Step 8: Reattach the Caliper

1. Slide the caliper back over the new brake pads.
2. Reinstall the caliper bolts and tighten them to the manufacturer’s torque specifications using the 3/8" torque wrench.

Step 9: Reinstall the Wheel

1. Place the wheel back onto the hub.
2. Hand-tighten the lug nuts.
3. Lower the vehicle off the jack stands.
4. Fully tighten the lug nuts to the manufacturer's specifications using the 1/2" torque wrench.

Step 10: Test the Brake System

1. Before driving, pump the brake pedal a few times to seat the brake pads against the rotor.
2. Check the operation of the electronic parking brake to ensure it functions correctly.

Conclusion

You have successfully replaced the rear brake pads on a 2020 Toyota Camry XLE with an electronic parking brake. Regularly checking and maintaining your brake system is essential for safe driving. If you experience any issues or if you're uncertain about any steps, consider consulting a professional mechanic for assistance.