Installing A Maxton Design Rear Diffuser (Seat Leon)

Introduction

This tutorial will guide you through the process of installing a Maxton Design rear diffuser on a Seat Leon. The rear diffuser is a popular modification that enhances the car's appearance and aerodynamics. While the installation may seem straightforward, there are important steps and considerations to ensure a successful fit.

Step 1: Remove the Old Diffuser

• Begin by inspecting the current rear diffuser.
• Identify the screws holding it in place:
  • Typically, you will find four to six screws.
• Use the appropriate tool to remove these screws. If you encounter tapping screws:
  • If you lack the right tool, a hammer can be used to gently tap them out.
• Carefully push in the clips to release the old diffuser:
  • Focus on the corner clips first, as they can be tricky.
  • If necessary, push from inside the bumper to aid in clip release.

Step 2: Prepare for the New Diffuser Installation

• Once the old diffuser is removed, clean the area where the new diffuser will be installed.
• Compare the new diffuser with the old one:
  • Note that the new diffuser may not have the same clip design.
• Prepare to drill new holes in the new diffuser:
  • Use masking tape to mark where to drill based on the old diffuser’s holes.
  • Ensure your drill is charged before starting.

Step 3: Drill Holes in the New Diffuser

• Carefully measure and mark the drilling points on the new diffuser using the masking tape for guidance.
• Drill slowly and cautiously to avoid cracking the diffuser:
  • It’s better to start with a smaller drill bit and gradually increase the size if necessary.
• Check fitment frequently by placing the diffuser against the bumper.

Step 4: Install the New Diffuser

• Once all holes are drilled, align the new diffuser with the holes in the bumper.
• Secure the diffuser in place using tapping screws:
  • Ensure that the screws are tight but avoid overtightening to prevent damage.
• Remove any protective film from the new diffuser for a clean look.

Step 5: Additional Modifications

• If you're also installing other modifications, such as wind reflectors:
  • Follow similar steps for alignment and securement.
• For decal stickers that enhance the grill's appearance:
  • Clean the area before application.
  • Use a small amount of fairy wash liquid to aid in repositioning the stickers during application.

Conclusion

Congratulations on successfully installing your Maxton Design rear diffuser! This modification significantly improves the aesthetic appeal of your Seat Leon. Remember to take your time during the installation process to ensure everything fits correctly. If you plan to make additional modifications, follow similar procedures for best results. Don’t forget to share your finished look and consider subscribing for more tips and tutorials!