Replacing the Hyundai Sonata Antenna Cover | Super Simple!

Introduction

This tutorial will guide you through the process of replacing the antenna cover on a Hyundai Sonata. Whether your antenna cover has been damaged or lost, this simple step-by-step guide will help you restore your vehicle's appearance and functionality.

Step 1: Gather Necessary Tools

Before you begin, make sure you have the following tools on hand:

• Small screwdriver (PH1)
• Wrench or pliers
• Interior trim removal tool
• New antenna cover

Step 2: Remove Interior Trim Clips

1. Locate the four interior trim clips that secure the trim around the antenna area.
2. Use your interior trim tool to carefully pry out each clip.
3. If your vehicle's trim is missing clips, you may have fewer to remove.

Step 3: Access the Antenna

1. Remove the armrest or shoulder piece from the interior trim (if applicable).
2. Pull away the rubber door trim to gain better access.
3. Gently pull down the headliner to expose the antenna wiring and clips.

Step 4: Disconnect the Antenna Wiring

1. Identify the wiring assembly connected to the antenna.
2. Use your pliers or wrench to carefully tug and disconnect the wiring connector.
3. Release the retainer by pushing it down, allowing you to fully detach the wiring.

Step 5: Remove the Old Antenna

1. If necessary, use a wrench to loosen any screws holding the antenna in place.
2. Remove the antenna from the mounting point on the roof.

Step 6: Install the New Antenna

1. Position the new antenna in the same spot as the old one.
2. Align it correctly and insert the antenna into the mounting area.
3. Pull down the headliner slightly to ensure proper placement.

Step 7: Reconnect the Antenna Wiring

1. Slide the wiring connector back into place.
2. Ensure the retainer is secured properly to hold the wiring.

Step 8: Reassemble the Interior Trim

1. Reattach the headliner and ensure it is aligned properly.
2. Reinsert the rubber door trim.
3. Reattach the armrest or shoulder piece if it was removed.
4. Push the interior trim clips back into their original positions.

Conclusion

You have successfully replaced the antenna cover on your Hyundai Sonata. Remember to check the stability of the antenna and ensure all clips are securely fastened. If you have any questions or need further assistance, feel free to leave a comment or check the link for the antenna cover purchase. Happy driving!