How to program a GMC Acadia remote key fob 2007 - 2010
2 min read
1 month ago
Published on Aug 02, 2024
This response is partially generated with the help of AI. It may contain inaccuracies.
Table of Contents
Introduction
This tutorial provides a step-by-step guide on how to program a remote key fob for a 2007 to 2010 GMC Acadia. This procedure is specifically for vehicles equipped with Driver Information Center buttons. Whether you have lost your remote or wish to add new ones, this guide will help you through the programming process.
Step 1: Prepare Your Vehicle
- Gather all remotes you intend to program, including those previously programmed.
- Insert the ignition key into the vehicle's ignition and turn it to the ON position. This is the position just before starting the engine.
Step 2: Access the Remote Key Programming Mode
- Locate the Driver Information Center button and press it until you see the display message "PRESS TO RELEARN REMOTE KEY."
- Once this message appears, press the SET/RESET button. You should see "REMOTE KEY LEARNING ACTIVE" displayed.
Step 3: Program the First Remote
- Take your keyless remote and press and hold both the LOCK and UNLOCK buttons simultaneously.
- Continue holding these buttons for approximately 15 seconds.
- Listen for a chime; this indicates that the remote has been successfully programmed.
Step 4: Program Additional Remotes
- If you have more remotes to program, repeat Step 3 for each additional remote.
- The GMC Acadia can accommodate a maximum of eight remotes.
Step 5: Exit Programming Mode
- Once you are done programming all remotes, turn the ignition key to the OFF position and remove the key from the ignition.
- This action will exit the programming mode.
Step 6: Test the Remotes
- Test each programmed remote to ensure they function correctly. Each remote should lock and unlock the doors without issue.
Conclusion
You have successfully programmed your GMC Acadia remote key fob. If you encounter any issues, double-check the steps to ensure all remotes were programmed correctly. For further assistance or more programming instructions, visit ProgramYourRemote.com.