Регулировка КЛАПАНОВ без ЩУПА. ГАЗ 2410 051 проект "Дежурная"

Introduction

This tutorial provides a step-by-step guide on how to adjust the valves of a GAZ 2410 engine without using a feeler gauge. This technique can be particularly useful for classic car enthusiasts or anyone interested in maintaining their Soviet-era vehicles. The method enhances engine performance and longevity while simplifying the adjustment process.

Step 1: Gather Necessary Tools and Materials

Before starting the valve adjustment process, ensure you have the following tools and materials ready:

• Wrench set
• Screwdriver
• Torque wrench
• Engine oil
• Clean cloths
• Service manual for reference

Practical Tips

• Always use tools that fit snugly to avoid damaging the bolts.
• Keep your workspace clean and organized.

Step 2: Prepare the Engine

1. Ensure Safety:

   • Park the vehicle on a flat surface.
   • Turn off the engine and let it cool down.
   • Disconnect the battery to prevent any electrical issues.

2. Remove Engine Covers:

   • Use a wrench to remove any covers obstructing access to the valve assembly.
   • Keep screws and parts organized for reassembly.

Step 3: Locate the Valves

• Identify the valve assembly on the engine.
• Refer to the service manual for diagrams if necessary to locate the intake and exhaust valves.

Step 4: Adjust the Valves

1. Set the Engine to TDC:

   • Turn the crankshaft until the piston of the cylinder you are adjusting is at the top dead center (TDC).
   • Use the timing marks on the crankshaft pulley for accuracy.

2. Check Valve Clearance:

   • For this method, you will not be using a feeler gauge. Instead, use a simple method of finger pressure.
   • Slowly tighten the adjusting screw until you feel resistance, then loosen it slightly until you can just move it with your fingers.

3. Tighten the Adjusting Screws:

   • Once satisfied with the clearance, securely tighten the adjusting screws with a torque wrench as specified in the service manual.
   • Repeat this process for each valve, ensuring you return to TDC after adjusting each one.

Step 5: Reassemble the Engine

• After adjusting all valves, replace the engine covers securely.
• Reconnect the battery.

Step 6: Test the Engine

1. Start the Engine:

   • Turn the ignition on and start the engine.
   • Listen for any unusual sounds that might indicate improper adjustment.

2. Check for Leaks:

   • Inspect the engine for any oil leaks around the valve covers.

3. Take a Test Drive:

   • Drive the vehicle for a short distance to ensure everything is functioning correctly.

Conclusion

Adjusting the valves on a GAZ 2410 without a feeler gauge is a straightforward process that can greatly enhance your vehicle's performance. By following these steps, you can maintain your classic vehicle effectively. Remember to refer to your service manual for specific torque settings and additional details. Happy driving!