Hvordan bytte bak bremseklosser på VW GOLF 6 (5K1) [BRUKSANVISNING AUTODOC]

Introduction

This tutorial will guide you through the process of replacing the rear brake pads on a VW Golf 6 (5K1) model, specifically for vehicles produced between October 2008 and November 2013. Regular maintenance of brake components is essential for vehicle safety and performance.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement, ensure you have the following tools and materials ready:

• Steel brush
• Brake cleaner
• Universal grease
• Anti-squeal lubricant or assembly paste
• Combination wrenches (13mm and 19mm)
• Socket wrenches (13mm)
• Wheel wrench (17mm)
• Torque wrench
• Brake caliper tool
• Pry bar
• Wheel chocks

Step 2: Safely Lift the Vehicle

1. Park the vehicle on a flat surface and engage the handbrake.
2. Place wheel chocks in front of the front wheels to prevent rolling.
3. Use a jack to lift the rear of the vehicle and secure it with jack stands.

Step 3: Remove the Wheel

1. Use the wheel wrench to loosen the lug nuts on the rear wheel.
2. Remove the wheel to access the brake assembly.

Step 4: Remove the Brake Caliper

1. Locate the caliper bolts; these are typically found on the rear side of the caliper.
2. Using a 13mm socket wrench, remove the caliper bolts.
3. Carefully slide the caliper off the brake rotor. Support it using a hook or hang it to avoid putting stress on the brake line.

Step 5: Remove the Old Brake Pads

1. Inspect the brake pads; they should slide out easily. If they are stuck, gently pry them out with the pry bar.
2. Take note of the orientation of the old pads for proper installation of the new ones.

Step 6: Prepare the New Brake Pads

1. Clean the caliper bracket and rotor with a steel brush and brake cleaner.
2. Apply a thin layer of anti-squeal lubricant or assembly paste on the back of the new brake pads to reduce noise.

Step 7: Install New Brake Pads

1. Insert the new brake pads into the caliper bracket in the same orientation as the old ones.
2. Ensure they are seated correctly and securely.

Step 8: Reinstall the Brake Caliper

1. Use the brake caliper tool to compress the caliper piston back into the caliper housing.
2. Slide the caliper back over the new brake pads.
3. Reattach the caliper bolts and tighten them securely with the 13mm socket.

Step 9: Reattach the Wheel

1. Place the wheel back onto the hub.
2. Hand-tighten the lug nuts before lowering the vehicle.
3. Once the vehicle is lowered, use the torque wrench to tighten the lug nuts to the manufacturer’s specifications.

Conclusion

Replacing the rear brake pads on your VW Golf 6 is a straightforward process that can enhance your vehicle's safety and performance. Always ensure you have the right tools and materials at hand, and follow the steps carefully. After the replacement, it’s a good practice to test the brakes at a low speed to ensure they are functioning correctly. If you have any uncertainty during the process, consult a professional mechanic.