Garage Door Help : How to Reset a Garage Door Keypad Outside
2 min read
1 month ago
Published on Aug 03, 2024
This response is partially generated with the help of AI. It may contain inaccuracies.
Table of Contents
Introduction
This tutorial will guide you through the process of resetting your garage door keypad from the outside. Whether you've forgotten your code or simply want to change it for security reasons, these steps will help you do it easily without needing to be inside your garage.
Step 1: Access the Learn Button
- Locate the learn button on the garage door motor.
- It is typically a small square button and can be red, purple, or orange.
- Press the learn button.
- This action puts the garage door motor into programming mode for about 30 seconds.
Step 2: Enter Your New Code
- Move to the keypad outside your garage.
- Enter your desired code.
- Press the enter button and hold it down for one to two seconds, then release it.
- To test the new code, press the enter button again.
- The garage door should respond by opening or closing.
Step 3: Changing an Existing Code
- If you need to change a previously set code, start by entering the old code.
- After entering the old code, press the pound button (#) and hold it for one to two seconds.
- Enter your new code.
- Press the enter button to finalize the change.
- Your new code is now set.
Conclusion
You have successfully reset your garage door keypad from the outside. Remember to keep your new code secure and change it periodically for enhanced security. If you encounter any issues, consult your garage door manual or contact a professional for assistance.