КАК АККУРАТНО СНЯТЬ⁉️Подшипник, который остался на оси мотор колеса Xiaomi PRO/2/1S/Essential/M365

Introduction

This tutorial will guide you through the process of removing a stuck bearing from the motor wheel axle of Xiaomi electric scooters, including models PRO, 2, 1S, Essential, and M365. Even though replacing bearings might seem straightforward, challenges can arise, especially when the bearing is stuck. This guide will provide you with effective methods to tackle this issue while ensuring you don't damage any components.

Step 1: Gather Necessary Tools

Before you start, make sure you have the following tools on hand:

• Bearing puller or a similar tool
• Hammer
• Flathead screwdriver
• Lubricant (like WD-40)
• Clean cloths for wiping

Step 2: Prepare the Scooter

• Turn off the scooter: Ensure the scooter is powered off to avoid any accidental activation.
• Remove the wheel: Detach the wheel from the scooter by unscrewing the bolts that hold it in place. Keep the screws in a safe location for reassembly.

Step 3: Assess the Bearing

• Inspect the bearing: Determine if the bearing has any visible damage. If it’s stuck, you will need to proceed with extraction.
• Apply lubricant: Spray some lubricant around the bearing to help loosen it up. Let it sit for a few minutes to penetrate.

Step 4: Use the Bearing Puller

• Position the bearing puller: Align the puller over the bearing. Make sure it grips securely.
• Tighten the puller: Slowly tighten the puller until you feel resistance. This will help grip the bearing firmly.
• Tap gently with a hammer: If necessary, lightly tap the puller with a hammer to help dislodge the bearing.

Step 5: Remove Any Remaining Pieces

• Check for debris: After removing the bearing, inspect the axle for any debris or remnants of the old bearing.
• Clean the area: Use a clean cloth to wipe down the axle and surrounding areas to ensure proper installation of the new bearing.

Step 6: Install the New Bearing

• Choose the correct bearings: For Xiaomi scooters, the following bearings are recommended:
  • Front motor wheel: NTN 6002 LLUC3 (2RS-C3) or SKF 6002-2RS-C3
  • Rear wheel: NTN 6001LLU (2RS) or SKF 6001-2RS
• Position the new bearing: Carefully place the new bearing onto the axle.
• Press the bearing in: Use the bearing puller again to press the new bearing into place, ensuring it’s seated correctly.

Conclusion

You've successfully removed and replaced a bearing on your Xiaomi scooter. Remember to reassemble the wheel and ensure all screws are tightened properly. If you encounter difficulties, don’t hesitate to reach out for help. Regular maintenance can prolong the life of your scooter, so keep an eye on those bearings! If you need to tackle more advanced maintenance or repairs, consider checking out additional tutorials or contacting a professional for assistance.