craftsman chainsaw model 358.350810 carburetor fuel line kit install HIPA

Introduction

This tutorial provides a step-by-step guide to installing a carburetor fuel line kit on a Craftsman chainsaw model 358.350810. This process is essential for maintaining your chainsaw's performance and ensuring it runs efficiently. Follow these instructions closely to successfully complete the installation.

Step 1: Gather Necessary Tools and Materials

Before starting the installation, make sure you have all the required tools and materials. This will streamline the process and prevent any interruptions.

• Tools needed:
  • Screwdriver set (Phillips and flathead)
  • Pliers
  • Fuel line cutter or sharp scissors
  • Small container for fuel
• Materials:
  • HIPA carburetor fuel line kit (available on Amazon or HIPA)

Step 2: Prepare the Chainsaw

To ensure safety and accessibility, follow these steps:

1. Remove the spark plug: This prevents accidental starting of the chainsaw.
2. Drain the fuel tank: Use a container to catch any residual fuel. This helps avoid spills and makes handling the carburetor easier.
3. Clean the work area: Ensure that your workspace is clean and organized to avoid losing small parts.

Step 3: Remove the Old Carburetor Fuel Line

Carefully remove the existing fuel line to make way for the new one.

1. Locate the carburetor: It’s usually found near the rear of the chainsaw.
2. Disconnect the old fuel line:
   • Use pliers to gently pinch and slide off the clamps securing the fuel line.
   • Pull off the fuel line carefully to avoid breaking any components.

Step 4: Install the New Fuel Line

Now, it's time to install the new fuel line from the HIPA kit.

1. Cut the new fuel line: Measure and cut the new line to the appropriate length using the fuel line cutter or scissors.
2. Attach the new fuel line:
   • Slide one end of the new fuel line onto the carburetor fitting.
   • Secure it with the clamp provided in the kit.
   • Connect the other end of the fuel line to the fuel tank, ensuring a snug fit.

Step 5: Reassemble the Chainsaw

After the new fuel line is installed, reassemble your chainsaw.

1. Reattach the carburetor cover: Make sure all screws are tightened properly.
2. Install the spark plug: Replace the spark plug and ensure it is tightened securely.
3. Refill the fuel tank: Use the appropriate fuel mixture for your chainsaw.

Step 6: Test the Chainsaw

Before using the chainsaw, it’s crucial to test that everything is working properly.

1. Start the chainsaw: Follow the manufacturer’s instructions to start your chainsaw.
2. Check for leaks: Observe the fuel line and connections for any signs of leaking.
3. Test performance: Let the chainsaw run for a few minutes to ensure it operates smoothly.

Conclusion

Congratulations! You have successfully installed a new carburetor fuel line kit on your Craftsman chainsaw model 358.350810. Regular maintenance like this is key to prolonging the life of your equipment and ensuring efficient performance. If you encounter any issues during the installation or have questions, consider consulting a professional or the manufacturer's guide for further assistance. Happy cutting!