[E63] How to change engine oil on a 2016-2021 Honda CR-V.

Introduction

This tutorial will guide you through the process of changing the engine oil on a 2016-2021 Honda CR-V. Regular oil changes are crucial for maintaining your vehicle's performance and longevity. By following these steps, you can perform this maintenance task safely and efficiently.

Step 1: Gather Necessary Tools and Materials

Before you begin, ensure you have all the required tools and materials ready:

• Engine oil (check your owner's manual for the correct type and quantity)
• Oil filter
• Oil filter wrench
• Socket wrench
• Oil drain pan
• Funnel
• Rags or paper towels
• Jack and jack stands (or ramps)
• Personal protective equipment (gloves, goggles)

Step 2: Prepare the Vehicle

1. Park on a Level Surface: Ensure the vehicle is parked on a flat area to prevent oil spillage.
2. Engage the Parking Brake: Always secure the vehicle by engaging the parking brake.
3. Lift the Vehicle: Use a jack to lift the front of the vehicle, then place jack stands for safety.

Step 3: Drain the Old Oil

1. Locate the Oil Drain Plug: Under the vehicle, find the oil drain plug at the bottom of the oil pan.
2. Remove the Drain Plug:
   • Use a socket wrench to loosen and remove the drain plug.
   • Allow the old oil to completely drain into the oil pan. This may take a few minutes.
3. Replace the Drain Plug: Once all oil has drained, clean the drain plug and reattach it securely.

Step 4: Remove the Old Oil Filter

1. Locate the Oil Filter: Find the oil filter, which is usually near the engine block.
2. Use the Oil Filter Wrench:
   • Attach the oil filter wrench to the old filter.
   • Turn counterclockwise to remove it. Be cautious, as some oil may spill out.
3. Prepare the New Filter:
   • Apply a small amount of new oil to the rubber gasket of the new oil filter. This helps create a better seal.

Step 5: Install the New Oil Filter

1. Screw in the New Filter:
   • Align the new filter and screw it in by hand until snug.
   • Avoid overtightening, as this can cause damage.

Step 6: Add New Engine Oil

1. Open the Hood: Locate the oil filler cap on the top of the engine.
2. Remove the Cap:
   • Use a funnel to pour in the new engine oil.
   • Check the owner’s manual for the correct oil capacity.
3. Replace the Cap: After adding the oil, securely replace the oil filler cap.

Step 7: Check for Leaks

1. Start the Engine: Run the engine for a few minutes to circulate the new oil.
2. Inspect for Leaks: Check around the oil filter and drain plug for any leaks.
3. Turn Off the Engine: After a few minutes, turn off the engine and let it sit for a minute.

Step 8: Dispose of Old Oil and Filter

1. Collect Old Oil: Pour the old oil into a sealed container.
2. Recycle: Take the old oil and filter to a recycling center or an auto parts store that accepts them.

Conclusion

Changing the engine oil in your Honda CR-V is a straightforward process that can save you money and ensure your vehicle runs smoothly. Remember to perform regular oil changes as recommended in your owner's manual. If you're unsure about any step, consider seeking professional assistance. Happy driving!