How to Do a Whirlpool Washer Reset & Recalibration

Introduction

This tutorial will guide you through the steps to reset and recalibrate your Whirlpool washer. If your washer is malfunctioning or you've recently installed a new part, recalibration is essential for optimal performance. This guide covers two types of resets and the primary recalibration command to get your washer running smoothly again.

Step 1: Performing a Basic Reset

1. Unplug the Washer: Disconnect the power cord from the outlet.
2. Wait for a Few Minutes: Allow the washer to sit unplugged for at least 5 minutes. This helps clear any stored error codes.
3. Plug the Washer Back In: Reconnect the power cord to the outlet.
4. Test the Washer: Turn on the washer and check if the issue has been resolved.

Step 2: Performing a Control Reset

1. Turn the Dial: Set the cycle selector dial to "Normal."
2. Press Start: Press the "Start" button and wait for the washer to initiate the cycle.
3. Cancel the Cycle: After a few moments, press the "Cancel" button to stop the cycle.
4. Set the Dial Again: Turn the dial back to "Normal" and press "Start" to begin a new cycle.

Step 3: Recalibrating the Washer

1. Enter Diagnostic Mode:
   • Turn the cycle selector dial to "Normal."
   • Press the "Start" button.
   • Quickly turn the dial to "Drain/Spin," then back to "Normal" three times (this should be done within 10 seconds).
2. Listen for Sounds: You should hear a series of sounds indicating the washer is entering calibration mode.
3. Complete Calibration: Let the washer complete the calibration process. This may take a few minutes.
4. End Calibration: The washer will automatically exit calibration mode. After it finishes, you can start a normal wash cycle to test functionality.

Common Pitfalls to Avoid

• Ensure that the washer is plugged in before attempting any reset.
• Perform the steps in the correct order to avoid confusion.
• Keep the washer door closed during recalibration for accurate results.

Conclusion

By following these steps, you can effectively reset and recalibrate your Whirlpool washer, resolving common issues and ensuring that new parts function correctly. If problems persist after recalibration, consider consulting the tech sheet for your specific model or seeking professional assistance.