Fahrradreifen wechseln: So wechselt man den Rennradreifen richtig

Introduction

In this tutorial, we will guide you through the process of changing a road bike tire step by step. Whether you're dealing with a flat or simply want to switch tires, this guide provides expert tips for a quick and effective tire change. Mastering this skill will not only save you time but also ensure that you can maintain your bike's performance on the road.

Step 1: Gather Necessary Tools

Before starting the tire change, make sure you have the following tools:

• Tire levers
• A new tire (if replacing)
• A pump or CO2 inflator
• A multi-tool (if needed for the wheel removal)
• Rags for cleaning

Step 2: Remove the Wheel

To access the tire, you need to remove the wheel from the bike:

1. Shift Gears: Shift the bike into the smallest chainring and the smallest rear cog. This makes it easier to remove the wheel.
2. Open the Brake: If your bike has rim brakes, open them to allow the wheel to pass through.
3. Loosen the Skewer or Axle: Depending on your bike's setup, either unscrew the quick-release skewer or use a tool to loosen the axle nuts.
4. Remove the Wheel: Carefully lift the wheel out of the dropouts.

Step 3: Remove the Tire

Now that the wheel is off, it’s time to take off the tire:

1. Deflate the Tire: If the tire is still inflated, press on the valve to release air.
2. Insert Tire Levers: Use tire levers to pry the tire away from the rim.
   • Insert one lever under the tire bead and hook it onto a spoke.
   • Insert a second lever a few inches away and slide it along the rim to lift the bead over.
3. Remove the Tire: Continue using the levers to work the tire off the rim. Do this for both sides if necessary.

Step 4: Inspect the Rim and Tube

Before installing the new tire, inspect the rim and the tube:

• Check for Damage: Look for any sharp objects, cracks, or damage on the rim that could cause issues later.
• Inspect the Old Tube: If reusing, check for punctures or wear. If in doubt, replace it with a new tube.

Step 5: Install the New Tire

Now it’s time to put the new tire on the rim:

1. Position the Tire: Start by placing one side of the tire bead onto the rim.
2. Insert the Tube: If using a new tube, slightly inflate it and place it inside the tire.
3. Fit the Second Bead: Carefully push the second bead of the tire onto the rim. Use your hands rather than levers to avoid pinching the tube.
4. Check Alignment: Ensure that the tire is evenly seated on the rim.

Step 6: Inflate the Tire

After the tire is installed, inflate it to the recommended pressure:

• Use a Pump or CO2 Inflator: Inflate the tire slowly to avoid any popping or pinching.
• Check Pressure: Use a pressure gauge if available, and ensure it falls within the tire's specified range.

Step 7: Reinstall the Wheel

With the new tire on, it’s time to put the wheel back on the bike:

1. Align the Wheel: Place the wheel back into the bike's dropouts.
2. Secure the Skewer or Axle: Tighten the quick-release skewer or axle nuts securely.
3. Re-engage the Brake: If you opened the brake, make sure to re-engage it.

Conclusion

Changing a road bike tire is a straightforward process if you follow these steps. With practice, you can do it quickly and efficiently, ensuring your bike is always ready for the road. Remember to regularly check your tires for wear and maintain the tools necessary for a tire change. Happy cycling!