2013 Sea Doo RXPX IBR Replacment + Sea-Doo Tech Tips with Ernesto Calas + Calas Performace
Table of Contents
Introduction
This tutorial provides a step-by-step guide on replacing the Intelligent Brake and Reverse (IBR) system on a 2013 Sea-Doo RXP-X. We'll cover essential tips from experienced technician Ernesto Calas, ensuring you successfully complete the replacement while enhancing your Sea-Doo's performance.
Step 1: Gather Necessary Tools and Materials
Before you begin the replacement process, make sure you have all required tools and parts on hand. This will save you time and make the job smoother.
- Tools needed:
- Socket set
- Wrench set
- Screwdrivers (flathead and Phillips)
- Pliers
- Torque wrench
- Replacement parts:
- New IBR system
- Gaskets and seals (if necessary)
Step 2: Prepare the Sea-Doo
Proper preparation is crucial for a successful replacement. Follow these steps:
-
Disconnect the Battery
- Remove the negative terminal to ensure safety while working on electrical components.
-
Remove the Seat and Engine Cover
- Unscrew any fasteners holding the seat and engine cover in place. Set them aside in a safe location.
-
Drain the Water
- If applicable, drain any water from the system to avoid spills.
Step 3: Remove the Old IBR System
With the Sea-Doo prepared, you can now access the old IBR system:
-
Locate the IBR Assembly
- The IBR is typically located near the rear of the watercraft.
-
Disconnect Electrical Connections
- Carefully unplug any electrical connectors attached to the IBR unit.
-
Remove the Fasteners
- Use your socket set to remove all bolts and screws securing the IBR system.
-
Take Out the IBR System
- Gently pull the system out from its housing, being cautious not to damage surrounding components.
Step 4: Install the New IBR System
Now it's time to install the replacement IBR system:
-
Position the New IBR
- Align the new IBR unit with the existing housing.
-
Secure with Fasteners
- Hand-tighten all bolts and screws before using a torque wrench to tighten them to the manufacturer's specifications.
-
Reconnect Electrical Connections
- Plug in all the electrical connectors you removed earlier.
-
Check for Proper Fit
- Ensure the IBR system is seated correctly and there are no gaps.
Step 5: Reassemble the Sea-Doo
Once the new IBR is in place, reassemble your watercraft:
-
Reattach the Engine Cover
- Secure the engine cover with the screws you previously removed.
-
Reinstall the Seat
- Place the seat back on and fasten it securely.
-
Reconnect the Battery
- Reattach the negative terminal to restore power to the Sea-Doo.
Conclusion
Replacing the IBR system on your 2013 Sea-Doo RXP-X can greatly enhance its performance and safety. By following these steps, you can ensure a smooth installation. Remember to double-check all connections and fasteners before taking your watercraft back on the water. For more tips and updates, follow Ernesto Calas on Instagram and Facebook, as well as visit the Calas Performance website. Happy riding!