réparation chasse d'eau mécanisme chasse WC إصلاح المرحاض

Introduction

In this tutorial, we will guide you through the process of repairing and installing a toilet flush mechanism. Whether you're dealing with a leaking toilet or need to replace the float, this step-by-step guide will help you effectively tackle the job with confidence.

Step 1: Gather Your Tools and Materials

Before you begin the repair, ensure you have the necessary tools and materials on hand:

• Adjustable wrench
• Screwdriver (flathead and Phillips)
• Replacement flush mechanism (if needed)
• New float (if necessary)
• Towels or a sponge (to soak up any spills)

Step 2: Turn Off the Water Supply

To avoid any water damage, follow these steps:

1. Locate the shut-off valve behind the toilet.
2. Turn the valve clockwise to shut off the water supply.
3. Flush the toilet to empty the tank, and use towels to soak up any remaining water.

Step 3: Remove the Toilet Tank Lid

1. Carefully take off the toilet tank lid and set it aside in a safe place.
2. Inspect the inside of the tank for any obvious signs of wear or damage.

Step 4: Disconnect the Flush Mechanism

1. Identify the flush mechanism, which typically includes the handle, chain, and flapper.
2. Loosen the nuts securing the flush valve at the bottom of the tank using your adjustable wrench.
3. Carefully disconnect the chain from the flapper.

Step 5: Install the New Flush Mechanism

1. If replacing the mechanism, position the new flush valve in the same spot as the old one.
2. Secure it by tightening the nuts you previously loosened.
3. Reattach the chain to the flapper, ensuring it has a little slack for proper operation.

Step 6: Replace the Float (if necessary)

If the float is damaged or not functioning properly:

1. Disconnect the old float from the arm.
2. Attach the new float by sliding it onto the arm.
3. Adjust the float to ensure it is at the correct water level.

Step 7: Turn the Water Supply Back On

1. Slowly turn the shut-off valve counterclockwise to restore the water supply.
2. Allow the tank to fill up and check for leaks around the connections.

Step 8: Test the Flush Mechanism

1. Once the tank is full, test the flush mechanism by pressing the handle.
2. Ensure that the flapper opens properly and the tank empties and refills without any issues.

Conclusion

You have successfully repaired the toilet flush mechanism! Remember to regularly check your toilet for leaks and proper functioning to avoid future issues. If you encounter any problems during the process, feel free to seek assistance or leave a comment for further guidance.