Live Streaming Lama Batere Kamera Awet - 18650 dummy Laiqul DIY

Introduction

This tutorial provides step-by-step instructions on how to create a DIY 7.4V battery solution for live streaming using a 18650 battery. By following these steps, you can enhance your camera's performance for live streaming sessions, such as with the Sony A6400, while ensuring a long-lasting power source.

Step 1: Gather Necessary Tools and Materials

Before you begin the assembly of your DIY battery solution, ensure you have all required materials at hand:

• 18650 Battery: A rechargeable lithium-ion battery.
• Battery Holder: To securely hold the battery.
• Step Down Module: To regulate voltage output.
• DC Jack Cable: For connections to the camera.
• Dummy Battery: Specifically for NP-FW50 USB compatible with your camera.
• Tools: Soldering iron, wire cutters, and a multimeter (optional).

Purchase Links

• 18650 Battery: Tokopedia | Shopee
• Battery Holder: Tokopedia | Shopee
• Step Down Module: Tokopedia | Shopee
• DC Jack Cable: Tokopedia | Shopee
• Dummy Battery NP-FW50: Tokopedia | Shopee

Step 2: Assemble the Battery Pack

Once you have all your materials, you can start assembling your DIY battery pack.

1. Insert the 18650 Battery into the battery holder.
2. Connect the Step Down Module:
   • Identify the input and output terminals on the step down module.
   • Solder the positive and negative wires from the battery holder to the input terminals of the module.
3. Wire the DC Jack Cable:
   • Connect the output terminals of the step down module to the DC jack cable, ensuring correct polarity (positive to positive and negative to negative).
4. Check Connections:
   • Use a multimeter to verify that the output voltage is 7.4V, ensuring compatibility with your camera.

Step 3: Prepare the Dummy Battery

To power your camera using the DIY battery pack:

1. Modify the Dummy Battery:
   • Carefully open the dummy battery casing.
   • Solder the wires from the DC jack cable to the corresponding terminals in the dummy battery.
   • Ensure a secure and insulated connection to prevent short circuits.
2. Reassemble the Dummy Battery:
   • Once soldered, carefully close the dummy battery casing.

Step 4: Connect to Your Camera

With your DIY battery pack ready, it’s time to connect it to your camera:

1. Insert the Modified Dummy Battery into your camera (Sony A6400).
2. Plug in the DC Jack from the battery pack into the camera’s power input.

Conclusion

You have successfully created a DIY 7.4V battery solution for your camera, enhancing its capability for live streaming. This setup allows for extended streaming sessions without worrying about battery life. Always ensure connections are secure, and monitor battery levels to avoid unexpected power loss during use. Happy streaming!