Добавляем функцию 360 кругового обзора на автомагнитолу TS10/TS18 Topway

Introduction

This tutorial will guide you through adding a 360-degree panoramic view function to your TS10 or TS18 Topway car multimedia system. This feature enhances the driving experience by providing a comprehensive view around your vehicle. It’s important to note that the 360-degree system is supported only on specific motherboard versions, so ensure compatibility before proceeding.

Step 1: Verify Motherboard Compatibility

Before installation, check the version of your motherboard:

• If you have a TS10 or TS10L motherboard, the 360-degree function is not supported.
• If you have a TS10M or TS18 motherboard, you can proceed with the installation.

How to Check Your Motherboard Version

• Navigate to the settings menu on your device.
• Look for the "About" section, which typically displays system information, including the motherboard version.

Step 2: Obtain the Necessary Equipment

To successfully add the 360-degree view function, you will need:

• A compatible camera system for 360-degree viewing.
• Appropriate installation cables and connectors.
• Access to your vehicle’s dashboard for installation.

Recommended Purchase Links

• Camera system can be found here.
• Additional accessories may be available on the same platform.

Step 3: Install the 360-Degree Camera System

Follow these steps for installation:

1. Position the Cameras: Place the cameras strategically around your vehicle (front, rear, left, and right).
2. Connect the Cameras: Use the installation cables to connect each camera to the multimedia system.
3. Secure the Cameras: Make sure that all cameras are properly mounted and secured to prevent movement.

Practical Tips

• Ensure the cameras have a clear view without obstructions.
• Test the camera positioning before finalizing the installation.

Step 4: Configure the System Settings

After physical installation, you will need to configure the system settings:

1. Go to the settings menu on your TS10M or TS18 device.
2. Look for the “Camera” or “360 View” settings option.
3. Enable the 360-degree function.
4. Adjust settings such as camera angles and display preferences.

Common Pitfalls to Avoid

• Forgetting to check camera views before securing them can lead to poor visibility.
• Not enabling the 360-degree function in settings may result in the system not functioning properly.

Conclusion

By following these steps, you can successfully integrate a 360-degree panoramic view into your TS10 or TS18 Topway multimedia system. Remember to verify motherboard compatibility, properly install the camera system, and configure the settings for optimal use. Enjoy enhanced safety and convenience while driving! If you have any questions, consider joining the community chat for support.