Fix LED Hyper Flash Turn Signal | Lifted Toyota Tundra Turn Signal Wiring

Introduction

In this tutorial, we will guide you through the process of fixing LED hyper flash turn signals on a lifted Toyota Tundra. This issue often arises when LED lights are installed, as they consume less power than traditional bulbs. We will specifically focus on wiring the iBrightstar 50W 6ohm load resistors, which can help mitigate the hyper flash by mimicking the resistance of standard bulbs.

Step 1: Gather Necessary Materials

Before you start, ensure you have the following materials ready:

• iBrightstar 50W 6ohm load resistors (available for purchase online)
• Wire strippers
• Electrical tape or heat shrink tubing
• Connector terminals (if needed)
• A multimeter (optional for testing)

Step 2: Identify the Wires

Locate the wiring harness for your turn signals. You will need to identify the following wires:

• Turn signal positive wire: This wire sends power to the turn signal.
• Ground wire: This wire completes the circuit back to the battery.

Practical Tip

Check your vehicle's manual or a wiring diagram for specific wire colors and locations to avoid confusion.

Step 3: Prepare the Load Resistor

1. Take the load resistor and identify its two terminals.
2. Use wire strippers to strip about half an inch of insulation from the ends of the wires you'll connect to the resistor.

Common Pitfall

Do not connect the resistor directly to the LED without wiring it in the circuit; this may cause damage to the LED or the resistor.

Step 4: Connect the Resistor

1. Connect one terminal of the load resistor to the turn signal positive wire.
2. Connect the other terminal of the load resistor to the ground wire.
3. Secure all connections using electrical tape or heat shrink tubing to prevent short circuits.

Real-World Application

This wiring technique is beneficial when upgrading to LED lights, as it ensures proper functionality without the hyper flash issue.

Step 5: Test the Turn Signals

1. Turn on your vehicle and activate the turn signals.
2. Observe if the turn signals operate at a normal blinking rate.

Practical Tip

If the turn signals still hyper flash, double-check your connections and ensure the resistor is properly connected.

Conclusion

You have successfully wired the iBrightstar 50W 6ohm load resistors to fix the LED hyper flash issue on your Toyota Tundra. This installation not only resolves the hyper flash but also enhances your vehicle's lighting system. For any further questions or feedback, feel free to leave a comment. If you found this tutorial helpful, consider subscribing for more automotive tips!