Setting Nol benda kerja | #WCS | dan tes apakah sudah sesuai atau belum

Introduction

This tutorial provides a step-by-step guide on setting up a workpiece using the GSK Krisbow SMK on the G54 coordinate system. It is essential for ensuring that the raw material is properly prepared and that no imperfections, such as scratches or cuts, are present. This guide will also cover the use of tools like an edge finder or centrofix to facilitate precise alignment.

Step 1: Prepare the Raw Material

• Ensure the raw material is finished and free of any imperfections.
• Check for scratches or gouges that may affect the machining process.
• Use appropriate materials, such as:
  • Paper
  • Fuller
  • Other protective layers

Step 2: Use Edge Finder or Centrofix

• Select the appropriate tool for locating the edge of the workpiece.
• Follow these steps for using an edge finder:
  1. Secure the edge finder in the spindle.
  2. Position the edge finder close to the workpiece.
  3. Activate the spindle at a low speed to engage the edge finder.
  4. Adjust the machine until the edge finder contacts the edge of the material.
  5. Note the position for accurate setup.

Step 3: Set the Work Coordinate System

• Access the machine's control panel to set the G54 coordinate system.
• Input the following:
  • X and Y coordinates based on the edge finder readings.
  • Z coordinate if necessary, depending on the machining operation.
• Save the settings to ensure they are retained for future operations.

Step 4: Test the Setup

• Conduct a test run to verify that the setup is accurate and the machine operates as expected.
• Monitor for any discrepancies during the test:
  • Listen for unusual sounds.
  • Observe for any misalignment or unexpected movements.
• Adjust the setup if necessary, and repeat the testing process until satisfied.

Conclusion

Setting up the workpiece correctly is crucial for the success of your machining operations. By following these steps, you can ensure that your raw materials are properly aligned and free of imperfections. Remember to use tools like edge finders and to test your setup thoroughly before proceeding with actual machining. This will help you achieve precise results and avoid costly errors in your projects.