2013 BMW X5 oil change DIY

Introduction

This tutorial provides a step-by-step guide on how to perform an oil change on a 2013 BMW X5. Changing your oil regularly is essential for maintaining engine health and performance. Follow these instructions carefully to complete the task successfully.

Chapter 1: Required Tools and Materials

Before starting your oil change, gather the following tools and materials:

• 19mm wrench or socket
• BMW oil filter cap remover
• 0W30 engine oil (approximately 6.9 quarts)
• Mann oil filter (model HU816)
• Brake cleaner
• Screwdriver (for oil filter removal)
• Funnel (if using oil cork bottles)

Make sure to work in a well-ventilated area and wear protective gloves.

Chapter 2: Preparing for the Oil Change

1. Open the Oil Fill Cap

   • Locate and remove the oil fill cap on the engine. Set it aside.

2. Remove the Oil Filter

   • Use the BMW oil filter cap remover and a 21mm socket to loosen the oil filter.
   • Once loosened, remove it by hand and allow the oil to drain completely.

3. Prepare the New Oil Filter

   • Remove the old oil filter and the O-ring using a screwdriver.
   • Take the new O-ring from the oil filter kit and dip your finger in some used oil.
   • Lubricate the new O-ring with the used oil to prevent it from snapping during installation.

4. Install the New Oil Filter

   • Snap the plastic piece (if applicable) back onto the new filter.
   • Insert the new oil filter, hand-tighten it first, and then secure it with a ratchet or wrench.

5. Clean the Oil Filter Housing

   • Use brake cleaner to clean the oil filter housing to avoid confusion with any future leaks.

Chapter 3: Draining the Old Oil

1. Access the Oil Drain Plug

   • If necessary, jack up your car and ensure it's secure on jack stands. The lift points are located on plastic pegs.

2. Loosen the Oil Drain Plug

   • Use a 19mm wrench or socket to loosen the oil drain plug.
   • Once loosened, remove it by hand and allow the oil to drain completely. This may take a few minutes.

3. Reinstall the Oil Drain Plug

   • Once all the oil has drained, reinstall the oil drain plug by hand to prevent cross-threading.
   • Tighten it securely with a wrench.

4. Clean the Drain Plug Area

   • Spray the area around the oil drain plug with brake cleaner to remove any oil residue.

Chapter 4: Adding New Oil

1. Prepare to Add Oil

   • For a jug, pour the oil directly through the fill hole. If using cork bottles, place a funnel in the fill hole for easier pouring.

2. Add New Oil

   • Pour approximately 6.9 quarts of 0W30 oil into the engine.

3. Reinstall the Oil Fill Cap

   • After adding the oil, ensure the oil fill cap is securely back in place.

Chapter 5: Resetting the Maintenance Light

• To reset the maintenance light, you will need a scanner capable of resetting maintenance lights. Unfortunately, there is no alternative method for this model.

Conclusion

Congratulations on successfully changing the oil in your 2013 BMW X5! Regular oil changes are crucial for engine longevity. Remember to keep track of your maintenance schedule and consider documenting your oil change for future reference. If you found this guide helpful, consider sharing it or subscribing for more automotive tutorials!