FixarTV | Bygga Innervägg

Introduction

This tutorial will guide you through the process of constructing an internal wall using metal studs. You'll learn the essential steps from framing to finishing, ensuring your wall is sturdy and ready for use. Whether you're looking to enhance soundproofing between rooms or create a new space, this guide has you covered.

Step 1: Frame the Wall with Metal Studs

• Gather your materials: metal studs, screws, and tools (screwdriver, level, measuring tape).
• Measure the area where you want to install the wall.
• Cut your metal studs to the appropriate lengths.
• Install vertical studs:
  • Start by marking the positions on the floor and ceiling.
  • Attach the top and bottom tracks to the ceiling and floor using screws.
  • Insert vertical studs into the tracks, spaced 60 cm apart.
  • Ensure all studs are plumb using a level.

Step 2: Install OSB or Plywood Panels

• Choose between OSB (Oriented Strand Board) or plywood sheets.
• Measure and cut the panels to fit between the metal studs.
• Secure the panels:
  • Position the cut panels against the studs.
  • Use screws to fasten the panels to the studs, ensuring they are flush with the edges.
• This layer will provide a solid base for attaching fixtures later.

Step 3: Insulate the Wall

• Select the appropriate insulation material for soundproofing.
• Cut the insulation to fit snugly between the studs.
• Install insulation:
  • Place insulation boards in the gaps between the studs.
  • Ensure the insulation is not compressed; it should remain loose to be effective.
• This step helps reduce noise transfer between rooms.

Step 4: Install Gypsum Boards

• Measure the wall area to determine the size of the gypsum boards needed.
• Cut the boards to fit.
• Attach the boards:
  • Start from one corner and work your way across.
  • Use screws to secure the gypsum boards to the metal studs.
  • Make sure the edges are aligned and the boards are flat.

Step 5: Apply Joint Compound

• Gather tools: joint knife and joint compound.
• Fill gaps and seams:
  • Use the joint knife to apply joint compound over seams and screw holes.
  • Smooth it out to create an even surface.
• Allow the compound to dry completely.

Step 6: Sand the Surface

• Once the joint compound is dry, use sandpaper or a sanding block.
• Sand any rough edges and seams until smooth.
• Ensure the surface is even and ready for painting or decoration.

Conclusion

You have now successfully built an internal wall using metal studs, insulation, and gypsum boards. Key steps included framing, insulating, and finishing the wall to ensure a sturdy and soundproof structure. Next, consider painting or adding decorative elements to personalize your new space!