Rear & Front Sight Installation Tutorial for the 2020 Colt Python - How To Walkthrough Guide

Introduction

This tutorial provides a step-by-step guide for installing Wilson Combat rear and front sights on the 2020 Colt Python. This guide will help you enhance your shooting accuracy with improved sight picture and adjustability.

Chapter 1: What You Will Need

Before you start the installation, gather the following tools and materials:

• Eye Protection: Always wear safety glasses when working with firearms.
• Tools:
  • Small flathead screwdriver
  • 1/16-inch punch
  • Roll pin starter
  • Hammer (any type)
• Tape: To protect the barrel of the revolver.
• Wilson Combat Sights: Rear sight (adjustable elevation and windage) and front sight (available in various colors).

Practical Tips

• Ensure your firearm is completely empty before beginning.
• Be mindful of your workspace to avoid losing small parts like roll pins.

Chapter 2: Removal of the Factory Rear Sight

1. Prepare the Firearm:

   • Confirm that the Colt Python is empty.
   • Tape around the barrel to prevent marring while mounted in a vise.

2. Remove the Elevation Screw:

   • Locate and unscrew the elevation screw at the top of the rear sight.

3. Drive Out the Roll Pin:

   • Secure the revolver in a vise.
   • Insert the 1/16-inch punch into the hole that retains the roll pin.
   • Gently tap the punch with a hammer to drive the roll pin out. Be careful towards the end to avoid losing the pin.

4. Check for Extra Parts:

   • If you lose the roll pin, Wilson Combat includes a replacement in the packaging.

Chapter 3: Installation of the Wilson Combat Rear Sight

1. Prepare the New Sight:

   • Take the aftermarket rear sight from the packaging.
   • Insert the spring into the recess on top of the new rear sight.

2. Install the Rear Sight:

   • Position the sight into the track of the revolver.
   • Use the 1/16-inch punch to hold the sight in place while aligning it.

3. Insert the Roll Pin:

   • Align the roll pin with the hole and use the roll pin starter to tap it in until you see movement.
   • Replace the punch with the roll pin starter, then switch to the punch to drive the pin fully in.

4. Reinstall the Elevation Screw:

   • Drop the elevation screw back in from the top and tighten it until you hear a positive click.

Common Pitfalls

• Ensure the spring is properly seated before installing the rear sight.
• Avoid over-tightening the elevation screw.

Chapter 4: Factory Front Sight Removal

1. Gather Tools:

   • Use the Allen wrench that comes with the new front sight.

2. Remove the Set Screw:

   • Locate the set screw at the front of the revolver near the muzzle.
   • Unscrew the set screw using the Allen wrench (the short end may provide better leverage).

3. Remove the Factory Front Sight:

   • Once the set screw is out, pull the front sight straight up and remove it.

Chapter 5: Installation of the Wilson Combat Front Sight

1. Prepare the New Front Sight:

   • Pre-load the new set screw onto your Allen wrench.

2. Install the New Front Sight:

   • Place the Wilson Combat front sight into position.
   • Hold it down with your thumb.

3. Reinstall the Set Screw:

   • Screw the set screw back in place.
   • For added security, apply a drop of blue Loctite to the set screw to prevent loosening.
   • Avoid using red Loctite as it can make removal difficult.

Conclusion

You have successfully installed the Wilson Combat rear and front sights on your Colt Python. Make sure to test your adjustments at the range and fine-tune your elevation and windage as needed. If you have any questions or need further guidance, feel free to reach out or leave suggestions for future tutorials. Happy shooting!