Siphon wechseln | austauschen | montieren

Introduction

In this tutorial, you will learn how to efficiently replace and install a siphon, commonly used in plumbing systems. This step-by-step guide will cover the assembly of the siphon and how to properly cut it to ensure a perfect fit. Follow these instructions to achieve a successful installation.

Step 1: Gather Necessary Tools and Materials

Before you begin, ensure you have the following tools and materials:

• New siphon (Röhrensiphon)
• Armaturenfett (fitting grease)
• Pipe cutter or saw
• Measuring tape
• Adjustable wrench
• Bucket (to catch any water)

Tips

• Always ensure the area is dry before starting.
• Keep a towel handy for any spills.

Step 2: Remove the Old Siphon

1. Turn off Water Supply: Ensure that the water supply to the sink or drain is turned off.
2. Place Bucket: Position a bucket underneath the siphon to catch any residual water.
3. Detach the Old Siphon:
   • Use an adjustable wrench to loosen the nuts connecting the siphon to the drain and the sink.
   • Carefully remove the old siphon, allowing any remaining water to drain into the bucket.

Common Pitfalls

• Be cautious not to overtighten the nuts when detaching, as this can cause damage.

Step 3: Measure and Cut the New Siphon

1. Measure the Required Length: Use a measuring tape to determine the necessary length for the new siphon based on your setup.
2. Mark the Cut: Mark the measurement on the new siphon where you will cut.
3. Cut the Siphon:
   • Use a pipe cutter or saw to make a clean cut at the marked line.
   • Ensure that the cut is straight to avoid leaks during installation.

Tips

• If you're unsure about the length, start with a longer piece and trim it down as needed.

Step 4: Assemble the New Siphon

1. Apply Fitting Grease: Lightly coat the threads of the siphon with armaturenfett to ensure a good seal.
2. Connect the Siphon:
   • Attach the siphon to the drain and sink, tightening the nuts with an adjustable wrench.
   • Ensure that the siphon is aligned correctly to prevent any kinks or bends in the pipe.

Practical Advice

• Make sure to hand-tighten first before using the wrench for a snug fit.

Step 5: Test for Leaks

1. Turn on the Water Supply: Slowly turn the water supply back on.
2. Check for Leaks: Observe the connections for any signs of leaking.
3. Tighten if Necessary: If you notice any leaks, carefully tighten the nuts until secure.

Conclusion

You have successfully replaced and installed a new siphon! Remember to check for leaks after installation and ensure all connections are secure. If you encounter issues, revisiting the measurements and connections can often resolve them. For further maintenance, periodically check the siphon to ensure it remains in good condition. Happy plumbing!