How To Install A New Delta Kitchen Faucet (Including Removal)

Introduction

This tutorial will guide you through the process of removing an old kitchen faucet and installing a new Delta Classic Kitchen Faucet. Whether you're a beginner or have some DIY experience, this step-by-step guide will help you save money by doing the task yourself instead of hiring a plumber.

Step 1: Gather Necessary Tools

Before starting, make sure you have the following tools on hand:

• Rigid Sink and Faucet Tool
• Pliers Set
• Crescent Wrench
• Screwdriver Set
• Flashlight
• Optional: Makita Cordless Drill Combo Kit, Dewalt Drill Bit Set, Allen Wrench Set, Utility Knife, Tape Measure, Stud Finder, Level, Hammer, Chisel Set, Voltage Tester, Wire Strippers, Ladder

Step 2: Prepare the Area

1. Clear the Space: Remove any items under the sink to give yourself enough room to work.
2. Turn Off Water Supply: Locate the shut-off valves under the sink and turn them clockwise to close them. If there are no valves, you may need to shut off the main water supply.
3. Drain the Faucet: Open the faucet to let any remaining water drain out.

Step 3: Remove the Old Faucet

1. Disconnect Water Supply Lines:

   • Use the crescent wrench to loosen and disconnect the supply lines from the old faucet.
   • Have a bucket or towel ready to catch any residual water.

2. Remove the Faucet:

   • If your faucet is secured with mounting nuts, use the rigid sink and faucet tool to loosen and remove them.
   • Lift the old faucet out of the sink.

3. Clean the Area: Wipe down the sink area to remove any debris or residue left from the old faucet.

Step 4: Install the New Faucet

1. Position the New Faucet:

   • Place the new Delta faucet into the sink hole. Ensure it is centered and aligned properly.

2. Secure the Faucet:

   • From underneath the sink, attach the mounting nuts to secure the faucet in place. Use the rigid sink and faucet tool for a firm grip.

3. Connect Water Supply Lines:

   • Reconnect the supply lines to the new faucet. Tighten with a wrench, being careful not to overtighten and damage the fittings.

Step 5: Test the Installation

1. Turn On Water Supply: Open the shut-off valves under the sink.

2. Check for Leaks:

   • Turn on the faucet to test the water flow.
   • Inspect all connections for leaks. If you notice any, tighten the connections as needed.

3. Final Adjustments:

   • Ensure the faucet operates smoothly and there are no drips.

Conclusion

You have successfully removed your old kitchen faucet and installed a new Delta Classic Kitchen Faucet. Remember to clean up any tools and materials used during the process. Keep an eye on the faucet over the next few days to ensure all connections remain leak-free. Enjoy your new faucet and the money saved from doing it yourself! If you encounter specific issues, feel free to seek help in the comments or consult a professional.