2016-2021 Honda Civic - Front Bumper Replacement

Introduction

This tutorial provides a step-by-step guide to replacing the front bumper on a 2016-2021 Honda Civic. Whether you're dealing with a damaged bumper or simply want to upgrade, this guide will help you complete the process efficiently, saving you time and money on professional repairs.

Step 1: Prepare the Vehicle

• Raise the vehicle and support it securely on jack stands.
• Open the hood to access the push clips on the top of the bumper.
• Ensure the tires are turned to the right and left for better access to the wheel well bolts.

Step 2: Remove Push Clips from the Top

• Locate and remove the push clips at the top of the bumper. You should find approximately nine clips.
• After removing the clips, take out the plastic component that covers the clips and set it aside.

Step 3: Disconnect Rubber Molding Clips

• Remove the rubber molding clips by gently pulling up the rubber and pressing down on the clips to release them.
• Ensure you do this on both sides of the bumper.

Step 4: Remove Side Bolts and Screws

• On each side of the bumper, locate and remove:
  • One push pin
  • One screw (typically a Phillips screw)
• If your vehicle has wheel well liners, also remove any clips or bolts attaching the bumper to the wheel well.

Step 5: Remove Bottom Push Pins and Bolts

• Underneath the bumper, remove any push pins and 10mm bolts attaching the bumper to the splash shield and undercarriage.
• This will help free the bumper for removal.

Step 6: Detach the Bumper

• Carefully pull the bumper away from the vehicle, starting at the sides.
• Be mindful of any electrical connections, especially if your Civic has fog lights. Disconnect any wiring harnesses as needed.

Step 7: Prepare for New Bumper Installation

• Bring the new bumper to your workspace and align it with the vehicle.
• Ensure that any necessary components (like fog lights) are prepared for installation.

Step 8: Attach the New Bumper

• Lift the new bumper into place, ensuring it aligns with the headlight assembly and clips into the designated channels.
• Secure the bumper with screws and push pins in the following order:
  • Attach the screws at the top and sides of the bumper.
  • Reinstall any screws or push pins in the wheel well and undercarriage.

Step 9: Reattach Any Additional Components

• Reinstall any plastic trim or rubber molding around the bumper.
• Ensure all push pins and screws are secure, including those that hold the bumper to the splash shield.

Conclusion

You have now successfully replaced the front bumper on your Honda Civic! Double-check all connections and fittings to ensure everything is secure. If you have any leftover clips or screws, verify that all components are accounted for. For further assistance or more repair videos, visit the YOUCANIC website. Happy driving!