VW Golf 2.0 TDi -- Front Lower Suspension Arm Rear Bush Replacement -- MK6 5K1

Introduction

This tutorial will guide you through the process of replacing the rear suspension bush on the front lower control arm of a MK6 5K1 VW Golf 2.0 TDi with DSG transmission. This task is essential for maintaining good handling and ride quality in your vehicle.

Step 1: Gather Tools and Parts

Before you start the replacement, make sure you have all necessary tools and parts. You won't need any special tools, but here's a list of what you will need:

• Parts:

  • Right-hand side bush and bolts (available here)
  • Left-hand side bush and bolts (available here)
  • Replacement ball joint nuts (available here)
  • Control arm bolt (available here)

• Tools:

  • Socket set
  • Torque wrench
  • Pliers
  • Hammer
  • Pry bar
  • Jack and jack stands

Step 2: Lift the Vehicle

• Use a jack to lift the front of the vehicle and secure it with jack stands for safety.
• Ensure the car is stable before you start working underneath it.

Step 3: Remove the Wheel

• Use a socket wrench to remove the lug nuts from the wheel.
• Take off the wheel to gain access to the suspension components.

Step 4: Disconnect the Lower Control Arm

• Locate the rear bush of the lower control arm.
• Remove the bolts securing the rear bush to the bracket. You will need to:
  • Use a socket wrench to loosen the bolts.
  • Remove the bolts and set them aside for later.

Step 5: Remove the Old Bush

• With the lower control arm loose, use a pry bar if necessary to help detach the old bush from the control arm.
• Inspect the area for any debris or damage.

Step 6: Install the New Bush

• Take the new bush and align it with the control arm.
• Push the bush into place. You may need to use a hammer gently to secure it fully.

Step 7: Reattach the Control Arm

• Position the control arm back into place and insert the new bolts for the rear bush.
• Torque the rear bush bolts as follows:
  • 50 Nm + 90 degrees for the bolts to the bracket.
  • 70 Nm + 90 degrees for the bolt to the body.

Step 8: Reattach the Wheel

• Once the control arm is secure, reattach the wheel.
• Tighten the lug nuts to the manufacturer's specifications.

Step 9: Lower the Vehicle

• Carefully remove the jack stands and lower the vehicle back to the ground.

Step 10: Final Checks

• Go through all connections and ensure everything is tight.
• Test drive the vehicle to check for any unusual noises or handling issues.

Conclusion

Replacing the rear suspension bush on your VW Golf can enhance your vehicle's performance and prolong its lifespan. Always make sure to follow safety protocols when working on your car. After completing this task, consider checking other suspension components for wear to maintain optimal handling.