Macbook pro 13 sostituzione dvd con hard disk extra ssd

Introduction

This tutorial provides a step-by-step guide on how to replace the optical drive in a non-Retina MacBook Pro with an additional SSD. This upgrade can enhance your laptop's performance by providing extra storage space and faster data access.

Step 1: Gather Required Tools and Materials

Before starting the replacement process, make sure you have the following tools and materials on hand:

• Compatible SSD drive
• Phillips screwdriver
• Torx screwdriver (T6)
• Plastic spudger or opening tool
• Anti-static wrist strap (recommended)
• External hard drive enclosure (optional for data transfer)

Step 2: Prepare Your MacBook Pro

• Shut down your MacBook Pro completely.
• Disconnect all peripherals and cables.
• Place the laptop on a soft, static-free surface to avoid scratches and static damage.

Step 3: Remove the Back Cover

• Use the Phillips screwdriver to remove the screws securing the back cover.
• Carefully lift off the back cover and set it aside.

Step 4: Disconnect the Battery

• Locate the battery connector on the logic board.
• Use the plastic spudger to gently lift the battery connector away from the motherboard to prevent any power supply during the installation.

Step 5: Remove the Optical Drive

• Identify the optical drive (DVD drive) inside the laptop.
• Use the Torx screwdriver to remove the screws securing the optical drive.
• Carefully disconnect the optical drive's connector from the motherboard.
• Slide the optical drive out of its bay.

Step 6: Install the New SSD

• Place the SSD into the optical drive bay.
• Align the SSD with the connector and gently slide it into place.
• Secure the SSD by replacing the screws you removed earlier.

Step 7: Reconnect the Battery

• Reconnect the battery connector to the motherboard firmly.
• Ensure it is properly seated to avoid any power issues.

Step 8: Replace the Back Cover

• Align the back cover with the MacBook Pro.
• Use the Phillips screwdriver to tighten the screws and secure the back cover.

Step 9: Boot Up and Format the SSD

• Power on your MacBook Pro.
• Open Disk Utility (found in Applications > Utilities).
• Select the new SSD from the list and click on "Erase" to format the drive.
• Choose the appropriate format (usually APFS or Mac OS Extended) and click "Erase" to complete the process.

Conclusion

You have successfully replaced the optical drive with an additional SSD in your MacBook Pro. This upgrade not only provides more storage but also improves system performance. If you wish to transfer data from your old hard drive, consider using an external enclosure for easy access. Enjoy your enhanced MacBook experience!