Cabo AUX no novo punto modelo 2012 até 2017: Como instalar o cabo aux

Introduction

This tutorial guides you through the process of installing an AUX cable in a Fiat Punto model from 2012 to 2017. With this setup, you can connect your phone or other audio devices to your car's sound system, enhancing your driving experience with your favorite music.

Step 1: Gather Your Materials

Before starting the installation, make sure you have the following materials on hand:

• A 3.5 mm P2 AUX cable
• Insulating tape
• 2 or 4 bicycle spokes (to help remove the sound system)

Step 2: Remove the Sound System

1. Use the bicycle spokes to carefully detach the sound system from the dashboard.
2. Ensure that you handle the components gently to avoid damage.

Step 3: Prepare the AUX Cable

1. Take one end of the P2 AUX cable and strip the insulation off.
2. You should see three wires: typically labeled as L (left), R (right), and GND (ground).
3. If you notice more than three wires, don’t worry; you will test each one.

Step 4: Locate the AUX Connector

1. Find the yellow connector at the back of the sound system. This connector is associated with the USB device.
2. If your connector is not yellow, consult the diagram attached to the sound system to find AUX 1 and AUX 2.

Step 5: Connect the Wires

1. Insert the stripped wires into the appropriate terminals of the AUX connector.
2. You may need to try different combinations:
   • Typically, two of the wires will produce good sound, while one may not work well.
   • Combine the two that work best, and leave the third wire isolated.

Step 6: Test the Connections

1. After connecting the wires, test the sound output.
2. If needed, adjust the combinations of the wires until you achieve the desired sound quality.

Step 7: Secure the Connections

1. Once satisfied with the sound, wrap the connected wires with insulating tape to prevent them from coming loose.
2. Ensure that the tape is secure and the connections are stable.

Step 8: Route the Other End of the AUX Cable

1. Pass the free end of the AUX cable through the sound system housing.
2. Position it to exit beneath the glove compartment for easy access.

Step 9: Reinstall the Sound System

1. Carefully place the sound system back into its original position.
2. Ensure everything is properly fitted and functioning.

Conclusion

You have successfully installed an AUX cable in your Fiat Punto, allowing you to connect various audio devices to your car's sound system. If you encounter any issues or have further questions, feel free to reach out for assistance. Enjoy your enhanced audio experience on the road!