PristineHydro 12-Month Filter Replacement (5 MICRON & KDF + CARBON Filters)
2 min read
1 day ago
Published on Jan 27, 2025
This response is partially generated with the help of AI. It may contain inaccuracies.
Table of Contents
Introduction
This tutorial guides you through the process of replacing the 5 MICRON and KDF + CARBON filters in your PristineHydro filtration system. Regular maintenance is essential to ensure your drinking water remains clean and safe. These filters should be replaced every 12 months for optimal performance.
Step 1: Prepare for Filter Replacement
-
Turn Off Water Supply
- Shut off the Angle Stop Valve to stop water intake.
- Turn off the tank valve.
-
Relieve Pressure
- Open the drinking faucet to relieve any pressure in the system.
- Ensure water has stopped flowing before proceeding.
Step 2: Replace the 5 MICRON Filter
-
Disconnect the Filter
- Unplug the red feed line from the 5 MICRON filter.
- Detach the filter from the top housing clips.
- Detach the filter from the bottom housing clips.
- Remove the outflow line by:
- Taking off the red clip.
- Pushing in the elbow connector while pulling out the outflow line.
-
Install the New Filter
- Insert the new 5 MICRON filter into the housing.
- Plug in the outflow feed line before remounting it.
- Ensure the feed line is not crimped for smooth water flow.
- Secure the filter back into the bottom and then top housing clips.
- Reconnect the red feed line to the 5 MICRON filter.
Step 3: Replace the KDF + CARBON Filter
-
Remove the Old Filter
- Use the provided filter wrench to turn the housing clockwise and release it.
- If it doesn’t come off easily, tap it gently to loosen.
- Check that the o-ring is seated properly to ensure a good seal.
-
Install the New Filter
- Place the new filter into the housing, ensuring the “THIS END UP” marking is oriented correctly.