RadRunner Full Fender Installation | Rad Tech

Introduction

This tutorial provides a step-by-step guide for installing full fenders on the RadRunner electric utility bike. Proper fender installation helps protect you and your bike from mud and water, enhancing your riding experience.

Step 1: Gather Your Tools and Components

Before you begin the installation, make sure you have the following tools and components ready:

• Full fender kit specifically for the RadRunner
• 4mm hex wrench
• 5mm hex wrench
• Flathead screwdriver
• Phillips screwdriver
• Adjustable wrench
• Safety glasses

Practical Tip

Ensure you have a clean, well-lit workspace to make the installation process smoother.

Step 2: Remove Existing Components

1. Disconnect the rear wheel:

   • Use the adjustable wrench to loosen the axle nuts on both sides.
   • Carefully lift the rear wheel out of the dropouts.

2. Remove the existing fender (if applicable):

   • If your RadRunner already has a fender installed, use your 4mm hex wrench to remove any screws and detach the fender from the frame.

Step 3: Install the Rear Fender

1. Position the rear fender:

   • Align the rear fender with the mounting brackets on the bike frame.
   • Ensure it fits snugly against the rear wheel without obstruction.

2. Secure the fender:

   • Use the 4mm hex wrench to tighten the screws provided in the fender kit into the mounting brackets.
   • Make sure the fender is level and stable.

Step 4: Install the Front Fender

1. Attach the front fender:

   • Position the front fender above the front wheel.
   • Align it with the mounting holes on the fork.

2. Secure the fender:

   • Use the 5mm hex wrench to tighten the screws into the fork.
   • Double-check that the fender does not interfere with the wheel’s movement.

Step 5: Reinstall the Rear Wheel

1. Reinsert the rear wheel:

   • Place the rear wheel back into the dropouts.
   • Use the adjustable wrench to tighten the axle nuts securely.

2. Check the alignment:

   • Ensure the wheel is straight and spins freely without rubbing against the fender.

Step 6: Final Checks

1. Inspect the installation:

   • Check all screws and bolts to confirm they are tightly secured.
   • Ensure there are no loose components that could affect safety while riding.

2. Test the bike:

   • Take a short test ride to ensure the fenders are functioning correctly and there are no issues with wheel clearance.

Conclusion

You have successfully installed full fenders on your RadRunner. Regularly check the fender screws and bolts for tightness, especially after long rides. If you encounter any issues or have questions, refer to the Rad Power Bikes Help Center for assistance. Happy riding!