Front bumper removal 2020 Chevy trax | Front bumper removal | headlight remove | front bumper

Introduction

This tutorial provides a step-by-step guide on how to remove the front bumper and headlights from a 2020 Chevy Trax. Whether you're performing maintenance, upgrading components, or accessing parts behind the bumper, this guide will equip you with the necessary tools, instructions, and safety tips to complete the task efficiently.

Step 1: Gather Your Tools

Before starting, ensure you have the following tools ready:

• T20 Torx screwdriver
• 8mm socket
• 10mm socket
• Screwdriver for trim clips
• Pliers (optional)

Step 2: Remove the Right Side Screws

1. Start on the right side of the vehicle.
2. Locate the three screws secured with a T20 Torx driver.
3. Turn each screw to the left to remove them.
4. Gently pop off the plastic trim piece, but do not remove it completely. Just lift it to expose the screw underneath.

Step 3: Remove the Left Side Screws

1. Move to the left side of the vehicle.
2. Repeat the same process as on the right side by removing the screws (use T20).
3. Pull back the liner to access the flare.

Step 4: Remove Bottom Screws

1. Get underneath the vehicle.
2. Locate and remove the following screws using an 8mm socket:
   • Two screws from the bottom area on the right side.
   • Two screws from the bottom area on the left side.
3. Locate additional screws under the bumper and remove them using the T20 Torx driver.

Step 5: Detach Clips and Shield

1. Remove the clips securing the upper shield. Use your tool to pry them out.
2. Once the clips are removed, take off the shield to access hidden screws.

Step 6: Remove Remaining Screws

1. Locate screws underneath the shield:
   • Use a 7mm socket for some screws and a 10mm socket for others.
2. Remove all visible screws to ensure the bumper is free.

Step 7: Disconnect Electrical Connectors

1. Look for any electrical connectors attached to the bumper.
2. Push back the safety clip and gently pull to disconnect the wiring harness.

Step 8: Remove the Bumper

1. With all screws and clips removed, carefully pull the bumper away from the vehicle.
2. Ensure that the bumper is free from any obstructions before completely removing it.

Step 9: Headlight Removal

1. Locate the screws holding the headlight in place.
2. Remove the screws with a 7mm socket.
3. Pry the headlight assembly gently out of its housing.
4. Disconnect the wiring harness by pushing back the red safety clip and pulling the black clip down while pulling the harness out.

Conclusion

You have successfully removed the front bumper and headlights from your 2020 Chevy Trax. Make sure to keep all screws and clips organized for reinstallation. If you're planning to replace parts or perform further repairs, follow the same steps in reverse to reattach everything. Always remember to double-check connections and screws to ensure everything is secure after reinstallation. Happy DIY-ing!