How to Replace Lexus LS 460 HID Headlight - Through Wheel Well--Complete Video

Introduction

This tutorial will guide you through the process of replacing the HID headlight in a 2007 Lexus LS 460 by accessing it through the wheel well. This method is advantageous as it avoids the need to remove the bumper, which can save you time and money. By following these steps, you can perform the replacement yourself and avoid dealership costs.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement, ensure you have the following tools and materials ready:

• Jack and jack stands
• Lug wrench
• Screwdriver (flathead and Phillips)
• Replacement HID headlight bulb
• Gloves (to avoid touching the bulb with bare hands)
• Clean cloth or paper towel

Step 2: Prepare the Vehicle

To safely access the headlight compartment:

1. Park on a Level Surface: Ensure the vehicle is parked on a flat surface.
2. Turn Off the Ignition: Make sure the vehicle is off to avoid any electrical issues.
3. Disconnect the Battery: For safety, disconnect the negative terminal of the battery.

Step 3: Lift the Vehicle

Follow these steps to raise the vehicle for access:

1. Loosen the Lug Nuts: Use a lug wrench to slightly loosen the lug nuts on the front tire.
2. Jack Up the Car: Position the jack under the vehicle's designated lifting point and raise it.
3. Secure with Jack Stands: Place jack stands under the vehicle for additional safety.
4. Remove the Front Tire: Completely remove the lug nuts and take off the tire to gain better access to the wheel well.

Step 4: Access the Headlight Compartment

Now that you have clear access:

1. Locate the Wheel Well Liner: Identify the plastic liner covering the headlight area inside the wheel well.
2. Remove the Fasteners: Use a screwdriver to take out the screws or clips securing the liner.
3. Pull Back the Liner: Carefully pull back the liner to expose the headlight assembly.

Step 5: Replace the HID Headlight Bulb

Once you have access to the headlight:

1. Locate the Headlight Connector: Find the connector attached to the back of the headlight bulb.
2. Disconnect the Connector: Gently pull the connector to detach it from the bulb.
3. Remove the Old Bulb: Twist the old bulb counterclockwise to release it from the housing.
4. Install the New Bulb:
   • Handle the new bulb with gloves or a clean cloth to avoid oil contamination.
   • Insert the new bulb into the housing and twist it clockwise to secure it.
5. Reconnect the Connector: Attach the connector back onto the new bulb.

Step 6: Reassemble the Vehicle

After replacing the bulb, reassemble everything:

1. Reattach the Wheel Well Liner: Pull the liner back into place and secure it with the screws or clips.
2. Reinstall the Tire: Place the tire back onto the hub, hand-tighten the lug nuts, and then lower the vehicle.
3. Tighten the Lug Nuts: Once the vehicle is on the ground, fully tighten the lug nuts in a crisscross pattern.
4. Reconnect the Battery: Reattach the negative terminal to the battery.

Conclusion

You have successfully replaced the HID headlight in your 2007 Lexus LS 460. This method not only saves you money but also gives you hands-on experience with vehicle maintenance. If you encounter any issues or have questions, don’t hesitate to consult the comments section of the original video for additional support or tips from others who have completed this task. Happy driving!