2018 - 2021 Jeep Compass Tail Light Removal - How To Remove & Change Brake Reverse Light Taillight

Introduction

This tutorial provides a step-by-step guide on how to remove and replace the tail light, reverse light, or brake light assembly on a 2018-2021 Jeep Compass. Whether you're changing a burnt-out bulb or replacing the entire assembly, these instructions will help you complete the task safely and efficiently.

Step 1: Prepare Your Vehicle

• Open the Jeep Compass liftgate to access the tail light assembly.
• Ensure you have the necessary tools on hand, including a T30 Torx screwdriver and a trim removal tool.

Step 2: Remove Tail Light Covers

• Locate the small plastic covers inside the tail light assembly.
• Gently pry these covers out using a trim tool, being careful not to damage them as they can break easily.

Step 3: Unscrew the Tail Light Assembly

• With the covers removed, you will see two T30 screws.
• Use your T30 Torx screwdriver to loosen and remove these screws.
• If the screws fall into the vehicle, it’s okay; just retrieve them later.

Step 4: Detach the Tail Light Assembly

• The tail light assembly is held in place by clips.
• You can either pull it off or use a trim tool to gently pry it away from the body of the Jeep.
• Look for a connector clip and press down to release it, allowing you to remove the assembly completely.

Step 5: Replace the Bulbs

• Orient the tail light assembly so you can see the bulbs.
• For each bulb, turn it a quarter to half turn counterclockwise to release it.
• Pull the old bulb straight out to remove it.
• Insert the new bulb by aligning the notches and turning it clockwise to secure it.

Step 6: Reinstall the Tail Light Assembly

• Reconnect the electrical connector to the assembly.
• Align the assembly with the clips and slots on the Jeep.
• Press firmly to ensure it is seated properly.

Step 7: Secure the Assembly

• Reinstall the two T30 screws you removed earlier.
• Tighten them securely to ensure the assembly is held in place.

Step 8: Replace Tail Light Covers

• Push the plastic covers back into place to conceal the screws.

Step 9: Close the Liftgate

• Once all components are secured and in place, close the Jeep Compass tailgate.

Conclusion

You have successfully removed and replaced the tail light assembly on your Jeep Compass. If you encounter any difficulties or have questions, feel free to seek assistance. Regular maintenance of your vehicle's lighting system is essential for safety, so be sure to check your bulbs periodically. Happy driving!