iFly 737 MAX Tutorial 1: Safety Inspection, Electrical Power Up & Walkaround | Real 737 Pilot

Introduction

This tutorial provides a comprehensive guide for performing a safety inspection, powering up the electrical systems, and conducting a walkaround of the iFly 737 MAX simulator. Following these steps will enhance your understanding of pre-flight procedures and ensure a safe and effective flight experience.

Step 1: Conducting a Safety Inspection

Before any flight, it’s crucial to perform a thorough safety inspection of the aircraft.

• Check the Exterior:

  • Inspect the fuselage for any visible damage or abnormalities.
  • Ensure that the wings are in good condition with no signs of tears or dents.
  • Verify that the landing gear is secure and functional.

• Review Safety Equipment:

  • Confirm that all emergency equipment, such as life vests and fire extinguishers, are onboard and accessible.
  • Check that the emergency exits are marked and functioning.

• Inspect Control Surfaces:

  • Ensure that ailerons, elevators, and rudders are free from obstructions and operate smoothly.

Step 2: Electrical Power Up

Powering up the electrical systems is essential for aircraft operation.

• Locate the Power Switch:

  • Find the main electrical power switch in the cockpit. This is usually located on the overhead panel.

• Power Up Procedure:

  • Turn on the battery switch first. This activates the essential electrical systems.
  • Next, switch on the generator to supply power to non-essential systems.

• Monitor Electrical Status:

  • Check the electrical status indicators on the cockpit displays to confirm that all systems are functioning correctly.
  • Ensure that there are no warning lights illuminated.

Step 3: Performing a Walkaround

A walkaround is a vital step to ensure the aircraft is ready for flight.

• Start from the Cockpit:

  • Exit the cockpit and visually inspect the area around the aircraft.

• Check Specific Areas:

  • Nose Section: Look for any leaks or damage.
  • Wings: Inspect fuel tanks for leaks and ensure flaps and slats are operational.
  • Tail Section: Verify that the control surfaces move freely and are in the correct position.

• Final Checks:

  • Return to the cockpit and check the fuel levels and weight distribution.
  • Confirm that all doors and hatches are securely closed.

Conclusion

Completing a safety inspection, powering up the electrical systems, and conducting a thorough walkaround are essential procedures for operating the iFly 737 MAX. These steps ensure safety and readiness for flight. After completing these processes, you can proceed to further training or flight simulation practices. Always remember to adhere to safety protocols and perform checks diligently before every flight.