SeaDoo Switch Wear Ring & Solas Impeller UPGRADE!

3 min read 2 months ago
Published on Jun 08, 2025 This response is partially generated with the help of AI. It may contain inaccuracies.

Introduction

This tutorial will guide you through the process of upgrading the wear ring and impeller on a 2023 Sea-Doo Switch with a 170hp engine. This upgrade not only enhances performance but can also improve acceleration and speed. Whether you're a seasoned DIY enthusiast or a beginner, these steps will help you complete the installation with confidence.

Step 1: Gather Necessary Tools and Materials

Before starting the upgrade, ensure you have the following tools and materials ready:

  • Tools:

    • Socket set
    • Screwdriver set
    • Pliers
    • Torque wrench
    • Utility knife
    • Clean rag
  • Materials:

    • New wear ring
    • Solas impeller (specific model for Sea-Doo Switch)
    • Marine grease (for lubrication)

Step 2: Prepare the Sea-Doo Switch

  1. Safety First:

    • Make sure the engine is off and cooled down.
    • Disconnect the battery to prevent any accidental starts.
  2. Access the Jet Pump:

    • Remove any panels or components blocking access to the jet pump.
    • This may involve unscrewing a few bolts or clips.

Step 3: Remove the Old Impeller

  1. Unscrew the Impeller:

    • Using the appropriate socket, remove the bolts securing the impeller.
    • Keep these bolts in a safe place for reinstallation.
  2. Detach the Impeller:

    • Carefully slide the old impeller off the shaft.
    • Inspect the shaft for any damage or wear.

Step 4: Replace the Wear Ring

  1. Remove the Old Wear Ring:

    • Use a utility knife to carefully cut away the old wear ring.
    • Be cautious not to damage the surrounding area.
  2. Install the New Wear Ring:

    • Clean the area thoroughly before installation.
    • Gently press the new wear ring into place.
    • Ensure it fits snugly and is aligned properly.

Step 5: Install the New Solas Impeller

  1. Apply Marine Grease:

    • Lightly coat the shaft and the inner part of the new impeller with marine grease.
  2. Attach the New Impeller:

    • Slide the new Solas impeller onto the shaft.
    • Secure it with the bolts you previously removed.
    • Use a torque wrench to tighten the bolts to the manufacturer’s specifications.

Step 6: Reassemble and Test

  1. Reattach Any Removed Components:

    • Replace any panels or parts that were removed for access.
    • Make sure everything is secured and in place.
  2. Reconnect the Battery:

    • Reattach the battery terminals and ensure a secure connection.
  3. Test the Upgraded System:

    • Start the engine and check for any unusual noises or leaks.
    • Take the Sea-Doo Switch for a test ride to experience the improved performance.

Conclusion

By following these steps, you can successfully upgrade the wear ring and impeller on your Sea-Doo Switch. This enhancement can lead to noticeable improvements in speed and acceleration, making your water adventures even more enjoyable. Always prioritize safety and if you encounter any challenges, consider consulting a professional mechanic. Happy boating!