Maytag series 4000 dryer idler pulley, belt and drum roller replacement (#96)

Step-by-Step Tutorial: Maytag Series 4000 Dryer Idler Pulley, Belt, and Drum Roller Replacement

1. Identify the Parts: Watch the video to identify the idler pulley, drum belt, and drum rollers on your Maytag Series 4000 natural gas dryer. Take note of the specific parts you need to order.

2. Prepare the Work Area: Locate the bottom panel of the dryer and remove the four quarter-inch screws using a quarter-inch extension or nut driver. Be cautious of sharp edges and remove any additional screws to create easier access.

3. Inspect and Clean: Before disassembling the dryer, inspect for any damage or worn-out parts. Clean the interior of the dryer to remove lint buildup.

4. Remove the Lid and Front Panel: Unscrew the three screws at the back of the lid to slide it back and remove it. Proceed to remove the faceplate and the front panel by unscrewing screws at the base and top.

5. Disconnect Wires: Disconnect all connectors and wires to detach the front of the dryer. Be gentle with plastic connectors that may have become brittle over time.

6. Inspect Drum Rollers and Felt Liners: Check the drum rollers and felt liners for lint buildup and signs of wear. Replace any damaged parts as needed.

7. Remove Drum Belt: Release tension on the idler pulley to remove the belt from the motor. Take note of how the belt is positioned for easier reinstallation.

8. Replace Parts: Lay out the new idler pulley, drum rollers, washers, and other necessary parts. Use tools like screwdrivers and needle-nose pliers to remove and replace components.

9. Apply Grease: Apply a thin coating of high-temperature grease on the posts before reinstalling the rear rollers and idler pulley.

10. Install Drum and Belt: Clean the felt inside the drum and place the belt on it. Install the drum with the new belt, ensuring it fits snugly on the rear rollers.

11. Reassemble Front Panel: Align the door panel with the tabs on the side and secure it in place. Reconnect wires and connectors, following the reverse order of disassembly.

12. Test the Dryer: Before fully reassembling the dryer, conduct a quick test to ensure it is functioning properly without any unusual noises.

13. Final Check: Once the dryer is working correctly, secure all screws and panels properly. Enjoy your repaired Maytag Series 4000 natural gas dryer.

By following these steps carefully, you can successfully replace the idler pulley, belt, and drum rollers on your Maytag Series 4000 dryer just like in the video tutorial.