How to Replace Starter 2007-2017 Ford Expedition

Introduction

This tutorial guides you through the process of replacing the starter on a 2007-2017 Ford Expedition. A faulty starter can prevent your engine from turning over, leaving you stranded. By following these steps, you can install a new starter and get your vehicle running smoothly again.

Step 1: Gather Required Tools and Safety Gear

Before starting the replacement, ensure you have the following tools and safety equipment:

• Pry Bar
• 13mm Socket
• Ratchet
• Swivel
• Torque Wrench
• Gloves
• Safety Glasses
• Floor Jack
• Wheel Chocks

Practical Tip

Always wear safety glasses and gloves to protect yourself from debris and sharp edges. Use wheel chocks to prevent the vehicle from rolling while you work.

Step 2: Prepare the Vehicle

1. Park the Vehicle: Ensure the vehicle is parked on a flat surface.
2. Engage the Parking Brake: This adds an extra layer of safety.
3. Disconnect the Battery: Remove the negative terminal from the battery to prevent any electrical issues during the replacement.

Step 3: Raise the Vehicle

1. Use a Floor Jack: Lift the front of the vehicle using the floor jack.
2. Secure with Wheel Chocks: Place wheel chocks behind the rear wheels to stabilize the vehicle.

Step 4: Locate the Starter

1. Access the Starter: The starter is located near the bottom of the engine, typically at the rear of the engine compartment.
2. Remove Any Obstructions: If necessary, remove any components blocking access to the starter.

Step 5: Remove the Old Starter

1. Disconnect Wiring: Carefully disconnect the electrical connectors from the starter.
2. Unbolt the Starter: Use the 13mm socket and ratchet to remove the bolts securing the starter to the engine.
3. Extract the Starter: Once unbolted, carefully remove the starter from its position.

Step 6: Install the New Starter

1. Position the New Starter: Align the new starter in the designated area.
2. Secure with Bolts: Use the 13mm socket and ratchet to reattach the bolts.
3. Reconnect Wiring: Ensure all electrical connectors are securely attached to the new starter.

Step 7: Lower the Vehicle

1. Remove Wheel Chocks: Take out the wheel chocks to prepare the vehicle for lowering.
2. Lower the Vehicle: Slowly lower the vehicle back to the ground using the floor jack.

Step 8: Reconnect the Battery

1. Attach the Negative Terminal: Reconnect the negative battery terminal and ensure it’s secured.

Step 9: Test the New Starter

1. Start the Engine: Turn the key in the ignition to test the new starter.
2. Listen for Unusual Noises: Ensure there are no abnormal sounds and that the engine starts smoothly.

Conclusion

Replacing the starter on your Ford Expedition can be a straightforward process if you follow these steps. Always prioritize safety by wearing protective gear and working in a secure environment. If the vehicle does not start after installation, double-check all connections and the battery status. Now that your starter is replaced, consider checking other components of your vehicle to ensure they are in good working order.