Wie Tiguan 1 Bremsscheiben hinten, Bremsbeläge hinten wechseln 🚗

Introduction

In this tutorial, you will learn how to replace the rear brake discs and brake pads on a Volkswagen Tiguan 1. This step-by-step guide will help you understand the necessary tools, parts, and techniques required for a successful brake replacement, ensuring your vehicle operates safely and efficiently.

Step 1: Gather Required Tools and Parts

Before starting the replacement process, gather all necessary tools and parts.

Tools Needed

• Wide flat screwdriver
• 15 mm open-end wrench
• Socket wrench
• Cross wrench
• Torque wrench
• 13 mm socket
• Torx T30 bit
• Hammer
• Wire brush
• M14 internal multi-tooth bit
• Joint handle
• Hydraulic jack
• Wooden block
• Jack stands

Parts Needed

• Brake discs
• Brake pads
• Brake cleaner
• Copper grease

Important Torque Specifications

• Brake disc retaining screw: 4 Nm
• Bracket screws: 90 Nm + 90°
• Thread rod screws: 35 Nm

Step 2: Remove the Brake Pads

1. Lift the Vehicle

   • Use a hydraulic jack to lift the vehicle securely and place jack stands underneath for safety.

2. Remove the Wheel

   • Unscrew the wheel bolts using a cross wrench and remove the wheel to access the brake assembly.

3. Remove the Brake Pad Retaining Clips

   • Use the flat screwdriver to carefully remove the retaining clips that hold the brake pads in place.

4. Extract the Brake Pads

   • Slide the brake pads out of their housing. If they are stuck, gently tap with a hammer to loosen them.

Step 3: Remove the Brake Disc

1. Remove the Bracket

   • Unscrew the screws holding the brake caliper bracket using a socket wrench.

2. Take Off the Brake Disc

   • Once the bracket is removed, the brake disc can be pulled off. If it is stuck, use a rubber mallet to gently tap it free.

Step 4: Install the New Brake Disc

1. Clean the New Brake Disc

   • Before installation, clean the new brake disc with brake cleaner to remove any protective oils.

2. Attach the New Brake Disc

   • Place the new brake disc onto the hub, ensuring it fits snugly.

3. Reattach the Bracket

   • Secure the bracket back onto the caliper using the previously removed screws, ensuring they are tightened to the specified torque.

Step 5: Install the New Brake Pads

1. Prepare the Brake Pads

   • Apply a thin layer of copper grease on the back of the new brake pads to prevent squeaking.

2. Insert the New Brake Pads

   • Slide the new brake pads into place within the caliper bracket.

3. Reinstall Retaining Clips

   • Replace the retaining clips to secure the brake pads.

Step 6: Final Checks

1. Reattach the Wheel

   • Place the wheel back onto the hub and tighten the bolts securely.

2. Lower the Vehicle

   • Carefully lower the vehicle back to the ground.

3. Test the Brake Pedal

   • Before driving, pump the brake pedal several times to restore brake pressure.

4. Initial Driving Caution

   • For the first 50 kilometers, drive cautiously and avoid hard braking to prevent glazing of the new brake pads.

Conclusion

Replacing the rear brake discs and pads on your Volkswagen Tiguan 1 can be done with the right tools and careful attention to detail. Ensure you follow the torque specifications and perform a thorough test of the brakes after the installation. For further maintenance, consider exploring additional tutorials or consulting a professional mechanic if needed. Happy driving!