How To: Whirlpool/Maytag Bearing & Tub Seal Kit Bearing Installation Tool W10435302 & W10447783

Introduction

This tutorial will guide you through the process of installing the Whirlpool/Maytag Bearing and Tub Seal Kit using the Bearing Installation Tool W10435302 & W10447783. This repair is essential if your washing machine is making excessive noise or if the seal has failed, leading to bearing issues. Following these steps will help you save time and money by performing the repair yourself.

Step 1: Gather Your Tools

Before starting the installation, ensure you have all the necessary tools and materials:

• Tape
• Towel
• Lanyard
• Putty knife
• Pliers
• 5/16" nut driver
• Small flathead screwdriver
• 7/16" socket with long extension
• Phillips screwdriver
• 1/4" hex head socket
• Ratchet with 3/8" socket
• Large pliers
• Big wrench
• Hammer
• Grease

Step 2: Disconnect the Washer

• Unplug the washer from the power supply to ensure safety.
• Turn off the water supply and disconnect the hoses.

Step 3: Remove the Washer Cabinet

• Use the putty knife to release the clips and detach the top panel.
• Remove screws using the 5/16" nut driver to take off the control panel.
• Slide the cabinet off to access the inner components.

Step 4: Remove the Old Bearing and Seal

• Carefully remove the old bearing and tub seal. You may need to use the large pliers or a flathead screwdriver to pry it out.
• Clean the area thoroughly to remove any debris or residue from the old seal.

Step 5: Install the New Bearing and Seal

• Apply grease to the new bearing and tub seal to ensure a smooth installation.
• Position the new bearing and tub seal into place, ensuring it fits snugly.

Step 6: Use the Bearing Installation Tool

• Insert the Bearing Installation Tool W10447783 over the new bearing.
• Use a hammer to gently tap the tool, ensuring the bearing is properly seated. Be cautious not to damage the surrounding components.

Step 7: Reassemble the Washer

• Reattach the washer cabinet by sliding it back into place and securing the screws.
• Reconnect the control panel and top panel, ensuring all clips are secured.

Step 8: Reconnect the Hoses and Power

• Reattach the water hoses and turn on the water supply.
• Plug the washer back into the power supply.

Conclusion

You have successfully replaced the bearing and tub seal in your Whirlpool or Maytag washer using the appropriate tools. This repair will help eliminate noise and prevent further bearing failures. If you encounter any issues or have questions, consider reaching out for technical support or checking the video for visual guidance. Enjoy your newly repaired washing machine!