VW / AUDI / SKODA Zadní brzdové kotouče | Zadní brzdové destičky [NÁVOD]

Introduction

This tutorial provides a step-by-step guide for replacing rear brake discs and pads on VW, Audi, and Skoda vehicles. Proper maintenance of brake components is essential for vehicle safety and performance. Follow these steps to ensure a successful replacement process.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement, make sure you have the following tools and materials ready:

• New rear brake discs
• New brake pads
• Socket set
• Wrench set
• Brake cleaner
• C-clamp or brake caliper tool
• Torque wrench
• Safety gloves and goggles

Practical Tips

• Ensure your vehicle is on a flat surface and that you engage the parking brake.
• Use quality parts to ensure safety and longevity.

Step 2: Remove the Wheel

1. Loosen the wheel nuts slightly while the vehicle is on the ground.
2. Raise the vehicle using a jack and secure it on jack stands.
3. Remove the wheel completely.

Step 3: Remove the Brake Caliper

1. Locate the caliper mounting bolts and remove them using the appropriate socket.
2. Carefully lift the caliper off the brake disc.
3. Support the caliper using a bungee cord or similar tool to avoid straining the brake line.

Common Pitfalls to Avoid

• Do not let the caliper hang by the brake line as this can cause damage.

Step 4: Remove the Old Brake Pads and Disc

1. Take out the old brake pads from the caliper bracket.
2. Remove the retaining screws or bolts from the brake disc using a socket.
3. Slide the old brake disc off the hub.

Step 5: Install the New Brake Disc

1. Clean the hub surface with brake cleaner to remove any rust or debris.
2. Position the new brake disc onto the hub.
3. Secure the disc with the retaining screws or bolts.

Step 6: Install New Brake Pads

1. Apply a small amount of brake grease to the back of the new brake pads to prevent noise.
2. Insert the new brake pads into the caliper bracket.

Step 7: Reinstall the Brake Caliper

1. Compress the caliper piston using a C-clamp or brake caliper tool.
2. Carefully position the caliper over the new pads.
3. Reattach the caliper mounting bolts and tighten them to the manufacturer's specifications using a torque wrench.

Step 8: Reinstall the Wheel

1. Place the wheel back onto the hub.
2. Hand-tighten the wheel nuts before lowering the vehicle.
3. Once on the ground, tighten the wheel nuts in a criss-cross pattern to the specified torque.

Step 9: Test the Brakes

1. Pump the brake pedal several times to ensure the brake pads are seated.
2. Check for any unusual noises or issues during initial testing.

Conclusion

Replacing the rear brake discs and pads on your VW, Audi, or Skoda can greatly improve your vehicle's braking performance. Always prioritize safety by using quality parts and following proper procedures. After completing the replacement, monitor the brakes during the first few drives to ensure everything is functioning correctly. If you encounter any issues, consult a professional mechanic for assistance.