Subaru Key Fob Remote Doesn’t Lock or Unlock Doors? - Easy Programming

Introduction

This tutorial provides a step-by-step guide on how to program a Subaru key fob remote that is not locking or unlocking the doors. Follow these instructions closely to ensure successful programming of your remote.

Chapter 1: Preparing for Programming

Before starting the programming process, make sure you have the following:

• A functional Subaru key fob remote.
• Your vehicle's ignition key.

Steps to Prepare

1. Open the Driver's Door: Ensure the driver's door is open.
2. Close the Door: Shut the door after opening it to prepare for the programming sequence.

Chapter 2: Ignition Cycling

The next step involves cycling the ignition to prepare for programming.

Steps to Cycle the Ignition

1. Insert the Key: Place your key in the ignition.
2. Cycle On and Off: Turn the ignition to the "On" position and back to "Off" 10 times. Ensure you end on the "On" position on the 10th cycle.
3. Listen for the Beep: After the 10th cycle, you should hear a beep sound (beep beep beep) and see the dome light blinking.

Chapter 3: Entering Programming Mode

Now that you're in programming mode, follow these steps to enter the key fob code.

Steps to Enter Programming Mode

1. Open and Close the Door: Open the driver's door and close it again. This signals the start of the programming sequence.
2. Input Your Code: Use the power lock switch:
   • For each digit of your code, press the lock button the number of times that corresponds to each digit.
   • Example: For the digit "1", press the lock button once, then press the unlock button to save.
   • Continue this for each digit in your code.

Example Code Input

• If your code is 1 3 2 4 1 1 8 2, do the following:
  • Press lock once for 1, then unlock.
  • Press lock three times for 3, then unlock.
  • Repeat this process for all digits.

Chapter 4: Finalizing the Programming

Once you have entered all digits, complete the programming process.

Steps to Finalize

1. Re-enter the Code: Input the same code again following the same procedure.
2. Listen for Confirmation: After entering the last digit, the doors should lock and unlock automatically as a confirmation.
3. Turn Off Ignition: Open the door, close it, and turn off the ignition.
4. Wait 5 Seconds: Remove the key from the ignition and wait for five seconds.

Chapter 5: Testing the Remote

Now that you have programmed the remote, it’s time to test if it works.

Steps to Test

1. Use the Key Fob: Press the lock and unlock buttons on the remote.
2. Check Functionality: Ensure the doors lock and unlock as expected. If it doesn’t work, repeat the programming steps.

Conclusion

Programming your Subaru key fob remote can be straightforward if you follow these detailed steps. Remember to be patient throughout the process, as it may take a few attempts to get everything right. If you encounter any issues, consider checking the compatibility of your remote, as aftermarket remotes might not work effectively. Happy driving!