Tutorial: S&B Crafty+ Replaceable Battery Mod

Introduction

In this tutorial, we will guide you through the process of replacing the battery in your S&B Crafty+ device. This modification allows for improved battery life and performance. It's important to follow the steps carefully to avoid any damage to your device.

Step 1: Gather Your Tools and Materials

Before starting the modification, ensure you have all the necessary tools and materials:

• Battery tube (available here)
• T6 Torque Screwdriver
• Small wire cutters
• Sandpaper
• Electrical tape
• Heat shrink tube (optional but recommended)
• Soldering iron (optional)

Tip: Ensure that the batteries you purchase are high drainage 18650 batteries (10A, 3.6V) from a reliable source, such as this link.

Step 2: Disassemble the Crafty+

• Use the T6 Torque screwdriver to carefully remove the screws from the device.
• Gently lift the top cover off to access the internal components.

Caution: Handle the device with care to avoid damaging any internal parts.

Step 3: Remove the Old Battery

• Identify the existing battery and note how it is connected.
• Use small wire cutters to disconnect the battery wires carefully.
• Remove the old battery from the compartment.

Step 4: Prepare the New Battery

• Take your new 18650 battery and ensure the positive side is facing upwards.
• If needed, use sandpaper to smooth out any rough edges on the battery compartment or connections.

Step 5: Connect the New Battery

• Connect the new battery to the existing wires, ensuring the positive and negative connections are correct.
• Use electrical tape to secure the connections, or apply heat shrink tube for extra durability.

Common Pitfall: Always double-check the polarity of the connections before powering on the device.

Step 6: Reassemble the Crafty+

• Carefully place the top cover back onto the device.
• Reinsert and tighten the screws using the T6 Torque screwdriver.

Step 7: Charge the Battery

• Do not use the charging port on the device for charging.
• Instead, use a dedicated 18650 battery charger to charge your new batteries.

Conclusion

By following these steps, you can successfully replace the battery in your S&B Crafty+ device. Remember to always insert the batteries with the positive side facing upwards and avoid using the internal charging port. For further modifications or improvements, consider exploring additional resources or community forums related to vaping devices. Happy vaping!