How to remove the rear bumper cover on 2003 Porsche 996 Turbo,

Introduction

This tutorial provides a step-by-step guide on how to remove the rear bumper cover from a 2003 Porsche 996 Turbo. This process is essential when performing maintenance tasks like replacing the water pump or accessing various components located behind the bumper.

Step 1: Prepare Your Tools

Before starting, gather the tools you'll need:

• 6mm hex screwdriver
• T27 Torx screwdriver
• Phillips screwdriver
• Flashlight (for better visibility)
• Magnet bowl (to keep screws organized)

Step 2: Remove the Rear Bumper Covers

1. Locate the small doors on the underside of the rear bumper.
2. Use a screwdriver or your fingernail to open the doors.
3. Inside, find the 6mm hex screw. Loosen it to remove the small black bumper cover.
4. Repeat this for the opposite side.

Step 3: Unscrew the Bumper Cover

1. Identify the screws:
   • Four screws on the top holding a metal plate.
   • Eight screws along the bottom (two under the wheel wells).
2. Start with the bottom screws:
   • Use a flashlight to see the screws better.
   • Begin with the two screws under the right wheel well.
   • Follow with three screws in the center and three screws on the left side.
3. For the top screws:
   • Remove the four screws holding the metal plate, starting from one side and working to the other.

Step 4: Remove the Bumper Cover

1. Carefully pull the sides of the bumper cover outward.
2. If you're alone, take your time to maneuver the bumper gently.
3. Ensure all screws are removed before attempting to pull the bumper away from the car.
4. If the bumper feels stuck, double-check for any remaining screws.

Step 5: Disconnect License Plate Light Cables

1. Once the bumper is loose, locate the electrical connector for the license plate lights.
2. Gently disconnect the cable to avoid damage.

Step 6: Remove Tail Lights (if necessary)

1. If the bumper is still attached, you may need to remove the tail lights.
2. Take out the screws holding the tail lights in place and carefully disconnect the wiring harness.

Conclusion

You have successfully removed the rear bumper cover from your 2003 Porsche 996 Turbo. This process allows you to access various components for maintenance or repair. Always ensure that you keep track of your screws and connectors to make reassembly easier. Once you're done, consider checking other parts behind the bumper for any necessary repairs or replacements.