STOP Looking down and relocate that GPS on your F850GS (F750GS)

Introduction

This tutorial guides you through relocating the GPS mount on your BMW F850GS or F750GS. The stock position of the GPS can be a safety concern as it requires looking down instead of focusing on the road. Relocating the GPS also allows for better tank bag placement. Let’s get started on this simple DIY upgrade.

Step 1: Gather Your Tools

Before starting the relocation process, make sure you have the following tools:

• Torx bits (T20, T25, T30, T50)
• Hex bits (3mm)
• Small ratchet set (1/4 inch drive)
• Extension bar
• Wire snips
• Small flathead screwdriver

Step 2: Remove the Windshield

1. Locate the four hex screws securing the windshield.
2. Use a 3mm hex bit to remove the screws.
3. Carefully set the windshield aside, ensuring you keep track of the screws.

Step 3: Remove the Plastic Cover

1. Use a flathead screwdriver to pry open the push buttons holding the plastic cover.
2. Gently remove the cover to expose the four Torx screws underneath.
3. Use a T30 Torx bit to remove these screws.

Step 4: Disconnect the GPS Cradle

1. Locate the GPS cradle and the cable attached to it.
2. Cut any zip ties securing the cable to the bike frame using your wire snips.
3. Use a T50 Torx bit to remove the four screws holding the cradle in place.
4. Be cautious of the nuts behind the screws to avoid losing them.

Step 5: Remove the Turn Signal Housing

1. Use a T25 Torx bit to remove the three screws from the turn signal housing.
2. Gently detach the housing, being mindful of the attached wire.
3. Disconnect the black and white plugs from the GPS cradle.

Step 6: Fish the GPS Cable

1. Fish the GPS cradle cable through the hole where the turn signal housing was located.
2. Reconnect the cable to the black and white plugs.

Step 7: Install the New GPS Relocation Bracket

1. Align the new GPS relocation bracket with the existing holes.
2. Use the T30 Torx screws to attach the bracket, tightening them by hand for now.
3. Insert the 12mm spacer and ensure the GPS cable is routed through the center.

Step 8: Reattach the GPS Cradle

1. Position the GPS cradle on the new bracket.
2. Secure it with the four tiny nuts, using a T20 Torx bit.
3. Tighten the screws while ensuring the cradle is positioned to your liking.

Step 9: Secure the Cables

1. Use zip ties to neatly secure the GPS cable to the new bracket.
2. Reinstall the turn signal housing, ensuring it is properly connected.

Step 10: Reattach the Windshield

1. Align the windshield back onto the bike.
2. Secure it with the four hex screws, tightening them appropriately.

Conclusion

You have successfully relocated your GPS mount on the BMW F850GS or F750GS. This improvement enhances safety and allows for better tank bag placement. If you have any questions or need further assistance, feel free to leave a comment. Enjoy your upgraded ride, and consider subscribing for more DIY motorcycle tips!