DIY Oil Change on 5th Gen Ram 1500 2019-24 V8 Hemi *EASIEST METHOD*

Introduction

This tutorial provides a step-by-step guide on how to perform an oil change on a 5th Gen Ram 1500 (2019-2024) with a V8 Hemi engine. Whether you're a beginner or just looking for an easier method, this guide will help you complete the task efficiently and cleanly.

Step 1: Gather Your Supplies

Before you start, make sure you have all the necessary tools and materials:

• Oil: Pennzoil Ultra Platinum Full Synthetic 5W-20 (7 quarts recommended).
• Oil Filter: WIX XP Oil Filter.
• Oil Filter Wrench: ARES 56036 Small Swivel Oil Filter Wrench.
• Funnel: For pouring new oil.
• Oil Drain Valve: Optional, but useful for easy future oil changes (F106SX: New Generation Fumoto Valve).
• Wrenches: 13mm wrench for the oil drain plug.
• Oil Drain Container: To collect old oil.
• Disposable Gloves: To keep your hands clean.
• Gallon Ziploc Bag: For minimizing mess when removing the oil filter.

Step 2: Prepare Your Vehicle

• Ensure your vehicle is on a flat surface and the engine is cool.
• If your truck is lifted, consider using a step stool for better access.

Step 3: Remove the Oil Cap

• Take off the oil cap to improve oil flow during draining. This allows air into the system, facilitating a smoother drainage process.

Step 4: Drain the Old Oil

• Locate the oil drain plug. Use your 13mm wrench to remove it.
  • If the plug is stuck, use two wrenches for leverage.
• Position your oil drain container beneath the plug.
• Allow the oil to drain completely. Wipe any spills to avoid leaks.

Step 5: Replace the Drain Plug

• Once all oil has drained, clean the area around the drain plug.
• Reinstall the drain plug and tighten it securely by hand, followed by a snug turn with the wrench.

Step 6: Remove the Old Oil Filter

• Use the swivel oil filter wrench to reach the oil filter.
• Wrap the Ziploc bag around the filter before loosening it to catch any oil.
• Turn the filter counterclockwise slowly, adjusting the bag as necessary to prevent spills.
• Once loose, pull the filter off and let it drain into the bag.

Step 7: Prepare the New Oil Filter

• Clean the surface of the engine where the filter attaches to ensure a good seal.
• Apply a bit of new oil to the rubber gasket of the new filter (this helps with sealing).
• Install the new oil filter by hand, tightening it snugly without overtightening.

Step 8: Add New Oil

• With the drain plug secured and the new filter in place, use the funnel to add new oil into the engine.
• Check your owner's manual for the exact oil capacity, ensuring you add the correct amount.

Step 9: Reset the Oil Life Indicator

• Turn the ignition to run mode (do not start the engine).
• Use the vehicle's controls to navigate to the vehicle info page.
• Find the oil life indicator and press and hold the 'OK' button until it resets.

Step 10: Clean Up

• Dispose of the old oil and filter properly at a recycling center.
• Wipe down any surfaces where oil may have spilled to prevent future leaks.

Conclusion

Congratulations! You have successfully changed the oil in your 5th Gen Ram 1500. Regular oil changes keep your engine running smoothly, so consider setting a schedule based on your driving habits. If you have any questions or need further assistance, feel free to reach out. Happy driving!