HOW TO MOUNT WIRE RIMS ON YOUR RIDE (Og Wire Wheels) | Cadillac Chronicles | Episode 12

Introduction

In this tutorial, you will learn how to mount OG wire rims on your vehicle, specifically a 1983 Cadillac Coupe Deville. This step-by-step guide is designed to help you achieve a successful installation while enhancing your lowrider's appearance and performance.

Step 1: Gather Necessary Tools and Materials

Before you start, make sure you have all the required tools and materials on hand to facilitate a smooth installation process.

• Tools Needed:

  • Jack and jack stands
  • Tire iron or lug wrench
  • Torque wrench
  • Wire brush or scraper
  • Cleaning supplies (soap and water)
  • Lubricant (grease or oil)

• Materials Needed:

  • OG wire rims
  • Tires suitable for wire wheels
  • Valve stems (if required)

Step 2: Prepare the Vehicle

Proper preparation of your vehicle is crucial for a successful installation.

1. Park on a Flat Surface: Ensure your vehicle is on a level surface to avoid any accidents while lifting.
2. Loosen Wheel Nuts: Use the tire iron to loosen the lug nuts on the wheels you plan to replace before lifting the vehicle.
3. Lift the Vehicle: Use a jack to lift the car and secure it with jack stands for safety.

Step 3: Remove Existing Wheels

Once the vehicle is properly prepared, you can remove the existing wheels.

1. Take Off Lug Nuts: Fully remove the loosened lug nuts and set them aside.
2. Remove the Wheel: Carefully pull the wheel off the hub, ensuring not to damage any components.

Step 4: Clean the Hub Area

Cleaning the hub area is essential to ensure a good fit for the new rims.

• Use a wire brush or scraper to remove any rust or debris.
• Clean the area with soap and water, then dry it thoroughly.

Step 5: Install the OG Wire Rims

Now you can proceed to install the new wire rims.

1. Mount the Tire: If the tire is not already mounted on the rim, do so according to the manufacturer's instructions.
2. Place the Rim on the Hub: Align the rim with the hub and slide it onto the hub.
3. Install Valve Stem: If applicable, ensure that the valve stem is in the correct position for easy access.

Step 6: Secure the Rim

Once the rim is in place, secure it properly.

1. Hand-Tighten Lug Nuts: Start by hand-tightening the lug nuts onto the wheel studs.
2. Use Torque Wrench: Once all nuts are hand-tight, use a torque wrench to tighten them to the manufacturer's specifications. This ensures the rim is securely fastened.

Step 7: Lower the Vehicle

After securing the rim, it’s time to lower the vehicle back to the ground.

1. Remove Jack Stands: Carefully remove the jack stands.
2. Lower the Jack: Slowly lower the vehicle back to its wheels.

Step 8: Final Checks

Perform a final check to ensure everything is in order.

• Check Lug Nut Tightness: Re-check the tightness of the lug nuts after lowering the vehicle.
• Inspect the Rims: Look for any signs of misalignment or issues with installation.

Conclusion

You have successfully installed OG wire rims on your 1983 Cadillac Coupe Deville. Remember, proper preparation and following each step carefully are key to a successful installation. Enjoy your newly upgraded ride! For further enhancements, consider exploring additional lowrider modifications or maintenance tips.