MAYTAG - HOW TO REPLACE THE WATER FILTER. MAYTAG REFRIGERATOR AIDE BY SIDE

3 min read 9 months ago
Published on Sep 07, 2024 This response is partially generated with the help of AI. It may contain inaccuracies.

Introduction

This tutorial will guide you through the process of replacing the water filter in a Maytag side-by-side refrigerator. Regularly changing your water filter ensures clean and safe drinking water, improving the taste and quality of the water dispensed from your fridge. Let's get started!

Step 1: Gather Necessary Materials

Before you begin, make sure you have the following items on hand:

  • Replacement water filter (check compatibility with your model)
  • Clean cloth or paper towel for any spills
  • Bucket or shallow pan to catch any water

You can find a compatible replacement filter at this link: Replacement Filter.

Step 2: Locate the Water Filter

Find the water filter compartment in your refrigerator. This is typically located:

  • Inside the refrigerator section, either on the upper right side or the back.
  • In some models, it may be found in the base grill at the bottom of the fridge.

Step 3: Remove the Old Water Filter

Follow these steps to remove the old filter:

  1. Turn off the water supply: Locate the water supply valve and turn it off to prevent any leaks.
  2. Open the filter compartment: If there’s a cover, remove it to access the filter.
  3. Twist or pull out the old filter: Depending on your model, either twist the filter counterclockwise or pull it straight out.
    • Tip: Be prepared for some water spillage.

Step 4: Install the New Water Filter

Now, insert the new water filter:

  1. Align the filter: Make sure the new filter is aligned properly with the compartment.
  2. Insert the filter: Push or twist the new filter into place until it locks securely.
    • Common Pitfall: Ensure the filter is fully seated to avoid leaks.

Step 5: Restore the Water Supply

Once the new filter is installed:

  1. Turn on the water supply: Open the valve to allow water to flow to the refrigerator.
  2. Check for leaks: Inspect around the filter area to ensure there are no leaks.

Step 6: Flush the New Filter

To ensure the new filter is properly functioning:

  1. Dispense water: Run water through the dispenser for about 5 minutes.
  2. Monitor water quality: Discard the first few glasses of water to flush out any carbon dust from the filter.

Conclusion

Replacing the water filter in your Maytag refrigerator is a simple process that can significantly enhance the quality of your drinking water. Make it a habit to check and change your water filter every six months or as recommended by the manufacturer. If you encounter any issues, refer to your refrigerator’s user manual or contact customer service for assistance. Enjoy your fresh water!