Frigidaire Refrigerator Replace Water Filter Base 807931801

Introduction

This tutorial provides step-by-step instructions for replacing the water filter base on a Frigidaire refrigerator. A common reason for this replacement is leakage from the filter base. By following these steps, you can successfully complete the repair and restore your refrigerator’s functionality.

Step 1: Prepare for the Repair

• Unplug the refrigerator to ensure safety during the repair process.
• Turn off the water supply to the refrigerator.
• Optionally, remove the upper shelving for better access to the water filter area.

Step 2: Remove the Existing Water Filter

• Rotate the water filter counterclockwise to detach it from the housing.
• Remove the access plug from the water filter housing.

Step 3: Detach the Water Filter Housing

• Use a quarter-inch nut driver to unthread the screws securing the housing.
• Pull the housing forward to remove it from the refrigerator.

Step 4: Disconnect the Incoming Water Line

• Remove the rear access panel by unthreading the screws holding it in place.
• Use a quarter-inch socket or nut driver to unthread the screws securing the water supply line retainer to the rear panel.
• Detach the water supply line from the inlet valve.
• Depress the locking ring with a small wrench to release the brown water tube from the inlet valve.

Step 5: Remove the Old Filter Base

• Unthread the screws securing the three tube retainers and slide them off.
• Unthread the screws securing the tube cover and lift it off.
• Pull the water filter input tube out of the zip tie retainer.
• Depress the locking ring to release the white outgoing line from the filter base to fully remove the old filter base.

Step 6: Install the New Water Filter Base

• Feed the incoming water line through the hole in the rear liner.
• Insert the outgoing water line into the new filter base and hook it onto the mounting stud.
• Feed the water filter input tube through the zip tie retainer and insert it into the appropriate port on the inlet valve.
• Apply some silicone in the tube channel to insulate the incoming and outgoing water filter lines.

Step 7: Reassemble the Components

• Reposition the tube cover and secure it with screws.
• Slide the retainers onto the tubing and secure them to the rear panel with screws.
• Reattach the water supply line to the inlet valve and secure it with the retainer.
• Align the water filter housing over the filter base and slide it back into place, securing it with screws.
• Snap the access plug back in.

Step 8: Finalize the Repair

• Replace the upper shelving if removed.
• Reinsert the water filter into the housing and rotate it clockwise to lock it in place.
• Turn the water supply back on and plug the power cord back in.

Conclusion

You have successfully replaced the water filter base in your Frigidaire refrigerator. If you experience any issues with this process or need further assistance, consult additional repair resources on the RepairClinic website. Regular maintenance and timely repairs can help extend the life of your refrigerator.