Jeep Grand Cherokee ULTIMATE Head Unit Upgrade - Teyes - Jeep WK2 -Android Auto -Apple CarPlay -DSP

Step-by-Step Tutorial: Upgrading Head Unit in a 2013 Jeep Grand Cherokee

Materials Needed:

• New Teyes head unit with all necessary components
• Screwdriver
• Pliers
• Microphone
• GPS antenna
• 5G Wi-Fi antenna
• External microphone
• USB port (optional)
• SIM card holder
• T15 Torx screwdriver
• Access to the vehicle's dash trim and components

Step 1: Removing the Existing Head Unit

1. Open the cubby hole located at the bottom of the dashboard.
2. Gently pull the plastic trim away from the dashboard to reveal the connectors at the back.
3. Disconnect the two connectors attached to the existing head unit.
4. Remove the four 7mm bolts holding the head unit in place.
5. Slide out the existing head unit and unplug any remaining connectors.

Step 2: Connecting the New Head Unit Components

1. Connect the main loom from the new Teyes system to the Jeep's loom.
2. Attach the adapter with the factory connector to the Jeep and the generic antenna to the Teyes system.
3. Plug in the canvas decoder and GPS antenna to the new head unit.
4. Extend and position the GPS and 5G Wi-Fi antennas above the dashboard vents.
5. Install the external microphone by threading it through access points under the steering wheel and plastic panel near the door.
6. Route the microphone cable along the pillar and behind the head unit, securing any excess cable neatly.

Step 3: Installing Additional Components

1. Secure the SIM card holder below the steering wheel for easy access.
2. Connect the microphone to the designated input on the head unit.
3. Consider installing USB ports in convenient locations like the armrest for accessibility.

Step 4: Mounting the New Head Unit

1. Remove the air conditioning controls, buttons, and vents from the old fascia.
2. Attach the components to the new head unit using the provided screws and screwdriver.
3. Secure the vents with adapters and remove any obstructive clips.
4. Transfer any clips from the old dash trim to the new one for proper alignment.
5. Place the fully assembled unit back into the dashboard.

Step 5: Finalizing the Installation

1. Connect the main loom, white wire, USB ports, SIM card, microphone, 4G antenna, Wi-Fi antenna, and GPS antenna to the new head unit.
2. Adjust any wiring to ensure a clean and organized setup.
3. Test all components to ensure they are functioning correctly.

By following these steps, you can successfully upgrade the head unit in your 2013 Jeep Grand Cherokee with a new Teyes head unit, complete with additional features and components for an enhanced driving experience.