FJ Mods: FJT-0814 fj cruiser andriod radio Step-by-Step Installation Guide.

Introduction

This tutorial provides a comprehensive guide to installing the FJT-0814 Android Radio in your Toyota FJ Cruiser. By following these steps, you can enhance your vehicle's audio system with advanced features and cutting-edge technology, ensuring a hassle-free installation process.

Step 1: Gather Necessary Tools and Materials

Before you begin the installation, ensure you have the following tools and materials ready:

• Flathead screwdriver
• Phillips screwdriver
• Panel removal tool
• Wiring harness adapter (if needed)
• FJT-0814 Android Radio unit
• User manual for the radio

Step 2: Disconnect the Battery

To ensure safety during installation, disconnect the vehicle's battery:

1. Open the hood of your FJ Cruiser.
2. Locate the battery and use a wrench to loosen the negative terminal.
3. Remove the negative terminal and set it aside to avoid accidental reconnection.

Step 3: Remove the Factory Radio

Follow these steps to safely remove the factory radio:

1. Use the panel removal tool to gently pry off the trim surrounding the radio.
2. Once the trim is removed, locate the screws holding the radio in place.
3. Use the Phillips screwdriver to remove the screws.
4. Carefully pull the factory radio out from its slot, ensuring you do not damage any wiring.

Step 4: Disconnect Wiring from the Factory Radio

With the radio out, disconnect the wiring:

1. Identify all connectors attached to the back of the factory radio.
2. Press down on the tabs and gently pull to disconnect each connector.
3. Make sure to note the arrangement of the wires for easier reconnection later.

Step 5: Prepare the FJT-0814 Android Radio

Get your new radio ready for installation:

1. Connect the wiring harness adapter to the FJT-0814 radio if required.
2. Ensure that all connectors are securely attached to the back of the radio.

Step 6: Install the New Radio

Now it's time to install the FJT-0814 radio:

1. Slide the new radio into the radio slot carefully.
2. Reattach the screws to secure the radio in place.
3. Replace the trim panel around the radio by snapping it back into position.

Step 7: Reconnect the Battery

After installing the new radio, reconnect the battery:

1. Place the negative terminal back onto the battery.
2. Tighten the terminal with a wrench to secure it.

Step 8: Test the New Radio

Before finishing up, ensure everything works correctly:

1. Turn on the vehicle.
2. Power on the FJT-0814 Android Radio.
3. Check all features (Bluetooth, radio, navigation, etc.) to confirm they function properly.

Conclusion

You have successfully installed the FJT-0814 Android Radio in your Toyota FJ Cruiser. By following these steps, you now enjoy enhanced audio performance and advanced features. For further customization or troubleshooting, refer to the user manual or visit the FJ Mods website for additional support and information. Enjoy your upgraded driving experience!